Practical coverage depends on the application method, painting conditions and the shape and roughness of the surface to be coated.

Drying Time:

Drying and recoating times are related to the film thickness, temperature, the relative humidity of the air and ventilation.

Gloss: Matt.

Colour Shades: Grey, Black.

Surface Preparation

• Oil, grease, salts and dirt are removed by appropriate means. (ISO 12944-4).

Steel surfaces:

• Blast clean to grade Sa2½. (ISO 8501-1) If blast cleaning is not possible, phosphating is recommended for cold rolled steel to improve adhesion.

Zinc Surfaces:

• Sweep blast clean with mineral abrasives, e.g. quartz sand, to an even roughness. (SaS, SFS 5873).
• If sweep blasting is not possible, the surface should be roughened by hand abrading or washed with Panssaripesu detergent.

Stainless Steel:

• Roughen the surface by grinding or sweep blasting using non-metallic abrasives.

Aluminium Surfaces:

• Sweep blast clean with non-metallic abrasives to an even roughness. (SaS, SFS 5873).
• If sweep blasting is not possible, the surface should be roughened by hand abrading or washed with Maalipesu detergent.

Recommended Primers

• Temanyl PVB.

Recommended Topcoats

• Duasolid 50.
• Temadur SC-F 20.
• Temadur SC-F 50.
• Temadur SCF 80.

Application Conditions

• All surfaces must be clean, dry and free from contamination.
• The temperature of the ambient air, surface and paint should not fall below 5ºC during application and drying.
• Relative humidity of the air should not exceed 80% during application and drying.
• The surface temperature of steel should remain at least 3°C above the dew point.
• Good ventilation and sufficient air movement is required in confined areas during application and drying.

Application

• Stir the product carefully before use.
• For airless spraying, the product is thinned approximately 30% to the viscosity 20–35s (DIN4).
• Recommended nozzle tip is 0.011"– 0.013" and pressure 120–160 bar.
• Spray angle shall be chosen according to the shape of the object.
• For conventional spraying, the product is thinned approximately 30% to the viscosity 20– 35s (DIN4).
• Recommended nozzle tip is 1.6–1.8 mm and pressure 3–4 bar.
• For dip coating, the product is thinned 30% to the viscosity 20s (DIN4).
• Note! When stoving Temanyl PVB before overcoating the temperature must not exceed +160ºC because the intercoat adhesion may then deteriorate.

Thinners

Thinner 1031

Cleaning Of Equipment

Thinner 1031

VOC

• The Volatile Organic Compounds amount is 690 g/litre of paint.
• VOC content of the paint (thinned 30% by volume) is 740 g/l.

Health And Safety

• Further information about hazardous influences and protection are detailed in individual health and safety data sheets.

For industrial and professional use only.

Please contact Rawlins Paints' Technical Support Team on 0113 2455450 (option 2) or send a message to [email protected] for more information.

Click to go back to the top of the page