Coo-Var Water Based All Metals Primer
Coo-Var Water Based All Metals Primer is a water thinnable acrylic metals primer which has very good anti-corrosive properties. It is low odour and easy to apply to most metals.
- Water based primer
- Interior and exterior
- Suitable Surfaces: Most Metals Inc. Iron, Steel, Aluminium, Brass, Copper
- Finish: Matt
- Application: Brush, roller or airless spray
Coo-Var Water Based All Metals Primer is a water based rust preventing general purpose metals primer. It is suitable for priming most metals including iron, steel, aluminium, brass, copper and more.
Ensure all surfaces are clean, dry and free from grease, oil and any other contaminates. Bare steel should be free from dust, rust and scale. Blast cleaning to SA 2½ is recommended. If blast cleaning is impractical, mechanical cleaning should be employed as hand cleaning does not clean the steel to the required degree.
Any oil or grease should be removed with CooVar Universal Degreaser before de-rusting. Where blast cleaning is carried out after assembly, special attention must be paid to edges, corners, nuts, bolts, welds etc. Welds should, if necessary be ground and all weld spatter, slag etc. must be removed.
Do not paint when temperature will be at 7°C or below during the painting and drying process. As dictated by normal good painting practice. Care must be taken during application that the temperature is above the dew point to avoid any contamination. In confined spaces, provide adequate ventilation during application and drying.
Do not paint when temperature will be at 7°C or below during the painting and drying process.
Features & Benefits
- Fast drying
- Overcoatable with virtually any paint
- Water thinnable
- Will over coat most existing coatings with very little chance of reaction due to the low solvent content
Coo-Var Water Based All Metals Primer has a very low V.O.C. content which means the product is fully compliant with the new 2010 regulations.
Please contact Rawlins Paints' Technical Support Team on 0113 2455450 for more information.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- Base Type
- Brush, Roller, Spray
- 12m² per litre
- Recommended Thinner/Cleaner
- Solids by Volume
- Touch Dry
- 1 Hour 30 Mins
- Recommended Dry Film Thickness
- 20-25 microns
- Recommended Wet Film Thickness
- 85 microns
- UN Number
Be the first to ask a question about this product!