Coo-Var Zinc Phosphate Primer
Coo-Var Zinc Phosphate Primer is a high performance, modified alkyd metal primer. It has very good anti-corrosive properties. Its high durability makes it ideal for use in coastal areas.
- Ideal when wood and metal are combined in the same structure as it will prime both surfaces
- A stronger primer than most basic DIY primers
- Can be used for fire escapes, metal gates, metal garage doors
- Can be used on aluminium
- Ideal in coastal areas
Coo-Var Zinc Phosphate Primer is a high performance, modified alkyd metal primer with very good anti-corrosive properties.
Coo-Var Zinc Phosphate Primer is primarily used as an anti-corrosive primer on iron and steel but is ideal when wood and metal are combined in the same structure as it will prime both surfaces. A stronger primer than most basic DIY primers, can be used for fire escapes, metal gates, metal garage doors and more. Can also be used on aluminium and is ideal in coastal areas.
Ensure all surfaces are clean, dry and free from grease, oil and any other contaminates. Bare steel should be free from dust, rust and scale. Blast cleaning to SA 2½ is recommended. If blast cleaning is impractical, mechanical cleaning should be employed as hand cleaning does not clean the steel to the required degree.
Any oil or grease should be removed with CooVar Degreaser before de-rusting. Where blast cleaning is carried out after assembly, special attention must be paid to edges, corners, nuts, bolts, welds etc. Welds should, if necessary be ground and all weld spatter, slag etc. must be removed.
As dictated by normal good painting practice. Care must be taken during application that the temperature is above the dew point to avoid any contamination. In confined spaces, provide adequate ventilation during application and drying.
Suitable topcoat, not for use below Rapidry products.
Please contact Rawlins Paints' Technical Support Team on 0113 2455450 for more information.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- Water / Solvent Based
- For Use On
- Iron, Steel
- Application Method
- Brush, Roller, Airless Spray
- Standard / Ready Mixed
- Single, Two or Three Pack
- Pack Size
- 1L, 2.5L, 5L
- Base Type
- Alkyd based
- Brush, Roller, Spray
- 13m² per litre
- Solids by Volume
- Touch Dry
- 2 Hours
- Semi Matt
- UN Number
Be the first to ask a question about this product!