Carboline Carboxane 2000 Topcoat is a two pack modified silane multi-polymer, and is a high performance, multi-purpose finishing product, allowing reduced coating specification in corrosion protection. It also adds a new dimension to finishing over Nullifire fire protection.

Click To Jump To Section:

• Features & Benefits
• Product Specification
• Film Thickness Range And Coverage
• Surface Preparation
• Product Notes
• Health & Safety

Features & Benefits

• Long life performance
• CDM/VOC compliant
• Reduced application costs
• Low VOC content
• Isocyanate free
• Outstanding gloss/colour retention

Carboline Carboxane 2000 Topcoat replaces:

• Carboline Carboxane 2000
• Carboline Carboxane WG

Product Specification

Film Thickness Range And Coverage

Coverage: 7.2m²/l at 125μm. Allow for loss in mixing and application.

Surface Preparation

General

• Surfaces must be properly cleaned.
• Employ adequate methods to remove dirt, dust, oil, and all other contaminantst that could interfere with the adhesion of the coating.

Steel

• Abrasive blast clean to SIS-Sa ½ (SSPC-SP10) producing a 50-75μm surface profile as determined by Keane Tator Surface Profile Comparator.
• Remove abrasive residues and dust from surface.

Galvanised Steel

• New and existing aged galvanising will require degreasing using Carboline Surface Cleaner 3.

Concrete

• Allow concrete to fully cure and dry.
• Remove all contaminants or laitancy by degreasing or light abrasive blasting, fill blow holes and allow all surfaces to thoroughly dry.

Aluminium

• Remove all oil, grease and other surface contaminants using Surface Cleaner 3 and lightly sweep blast or Sponge Jet.

Stainless Steel

• Remove all oil, grease and other surface contaminants using Surface Cleaner 3and lightly sweep blast or Sponge Jet.

Existing Coatings

• Remove all loose material and abrade. Seal surfaces using Rustbond Penetrating Sealer and allow to dry.

Inorganic Zin (IOZ)

See product data sheet for overcoating periods, remove soluble salts and apply a mist coat of Carboxane 2000 prior to full coat.

Product Notes

Note:

• Metallic colours must be conventionally spray applied, do not brush or roller.
• Certain colours may require 2 coats of Carboxane 2000 for opacity. For external use 2 coats by brush are normally preferred, when spray application is not possible due to restriction of site working.

Health & Safety

• Refer to the safety data sheet in the attachments section above and tin label prior to use.