We no longer stock this product, but can recommend RSL Resutile as a great alternative.

Resutile Wall is a high-grade coating designed to protect your walls from higher temperatures and robust heavy-duty environments such as aerospace areas. It is easy to clean and hygienic, making it ideal for the healthcare industry and detention centres.

Recommended Uses

• Prisons and police cells
• Hospitals and surgeries
• Chemical plants
• Pharmaceuticals
• Laboratories
• Aircraft hangars

Suitable surfaces

• Plaster
• Brick
• Blockwork
• Ceramic tiles
• Concrete

Preparation

Surfaces to be coated must be clean, sound, dry and free of any contaminants that could impair good adhesion. Hard smooth surfaces should be abraded or sanded to provide a mechanical key. Where open block work is to be coated this should be filled and bag rubbed with a sand cement mix to create a continuous, smooth paintable surface. Substrate temperature should be between 10-30oC with relative air humidity of 70% maximum. Cold, high humidity and lack of air movement can cause a patchy finish, gloss reduction and delay in curing and damage to final properties. To prevent this ensure good drying conditions and air ventilation prevail throughout the application and cure of the product.

Priming

Open and porous substrates will require priming. Resuseal WB Clear is recommended and depending on the porosity and texture of the surface to be primed may require two coats. Resuseal WB Clear will not seal block work as it is a thin film primer only.

Application

Mixing: Pre-mix the base component to a uniform consistency then add the entire contents of the hardener to the base and mix by using a slow speed, handheld, powered mixer and mixing paddle for approximately two to three minutes to achieve consistent mixture.

Note: Do not use a separate mixing bucket as it may affect the mixing ratio. The mixed unit should be applied immediately by roller or brush with a consistent procedure, cross-rolling to ensure even application and to minimise roller marks.

Do not add solvent to this product as it could adversely affect the final finish and properties of the coating.