Zinsser AllCoat Interior (Solvent-Based)

Rust-Oleum 9200 Rust-O-Thane is a satin, water based polyurethane which offers a very durable and colourfast finish on coated floors, walls and primed metal. It is available in RAL and BS colours so you should be able to find a colour to compliment your existing finishes.

We would recommend Zinsser Allcoat Exterior Satin Water Based be used on a composite door. The surface would need to be clean, dry and lightly abraded prior to application.

Not all products suitable for external use would be recommended for use internally, it would depend on the individual product and the application.

Yes that is correct, it will cover nicotine stains without the need of a separate primer.

Assuming the walls or timber are clean, dry, sound and prepared as detailed in the Technical Data sheet we can recommend priming first with Zinsser Cover Stain followed by two coats of Zinsser Perma-White Interior.

This can be mixed in many RAL and BS colours in a matt or satin finish.

Thank you for the enquiry, we have contacted you directly for more infomration.

Assuming the substrate is clean, dry, sound, prepared as detailed in the Techncial Data Sheet and a test for compatiblilty and adhesion is donr prior to full application this could be applied to tiles.

But this product is not designed to be heated or come in direct contact with flames so may not be suitable if close to the heat source.

Assuming the steel window frames are clean, dry, sound and prepared as detailed in the Technical Data sheet we can recommend Rust-Oleum 3369/3380 CombiPrimer Anti-Corrosion followed by 2 coats of Rust-Oleum Combicolor Original.

This is available in many RAL and BS colours in a satin or gloss finish.

This would be suitable for application to metal subject to condensation.

Assuming the cabinet is not exposed to direct water contact, it is clean, dry, sound and prepared as detailed in the Technical Data sheet we can recommend Bulls Eye 1-2-3 followed by Zinsser Perma-White Interior.

This is available in many RAL and BS colours in a satin or matt finish.

Zinsser Bulls Eye 1-2-3 is a good primer for MDF, it does raise the fibres slightly but it will seal the MDF very well. A light rub down with fine sandpaper will remove the raised fibres. Zinsser B-I-N can also be used, this doesn’t raise the fibres but may need more coats to completely seal the MDF.

Zinsser AllCoat Exterior Satin (Water Based) or Zinsser AllCoat Exterior Gloss (Water Based) would be the better option for both interior and exterior uPVC. Interior uPVC surfaces will need to be lightly abraded first then wiped down to remove dust and surface contamination before applying 2 coats AllCoat Exterior Satin or Gloss. Exterior surfaces which have been weathered can be washed down using warm water and dilute detergent followed by rinsing off with clean water and then 2 coats AllCoat Exterior Satin or Gloss.

For kitchen units we would normally recommend Zinsser B-I-N followed by Zinsser Perma-White Interior.

Yes, but for exterior projects we would recommend Zinsser AllCoat Exterior Satin (Solvent Based).

Application Data:
Brush, roller or pad: natural bristle or lambskin
Airless Spray: .017” tip @ 2200-2800 psi, minimum pump size: ¾ G.P.N

Dry Times (24°C):
To touch: 1 hr
To recoat: 2hrs
Stain sealing: 2hrs
Full scrape cure: 7 days

Cleanup:
Clean up spills and drips immediately with White Spirit. Rinse application tools in White Spirit immediately after use. Follow manufacturer’s instructions to clean spray equipment.