Sikagard 551 S Elastic Primer
Sikagard 551 S Elastic Primer is apPrimer for very dense or porous concrete surfaces or difficult application conditions. Sikagard 551S Elastic Primer is a one component solvented primer for Sikagard 550 W Elastic, Sikagard 545 W Elastofill and Sikagard 675 W ElastoColor.
Sikagard 551 S Elastic Primer is a one part, solvent containing primer for very dense or very porous concrete surfaces and/or difficult application conditions. Sikagard 551 S Elastic Primer is part of a system that complies with the requirements of EN 1504-2 as protective coating.
Priming of very dense concrete and of very porous concrete (having a tensile strength lower than 1 N/mm²). Sikagard 551 S Elastic Primer can also be used as primer on firmly adhering existing solvent based coatings.
Sikagard 551 S Elastic Primer is part of the system:
- Suitable for protection against ingress (Principle 1, method 1.3 of EN 1504-9)
- Suitable for moisture control (Principle 2, method 2.2 of EN 1504-9)
- Suitable for increasing the resistivity (Principle 8, method 8.3 of EN 1504-9)
- Ideal as a primer for Sikagard 550 W Elastic, Sikagard 545 W Elastofill and Sikagard 675 W ElastoColor
Features and Benefits:
- Deep penetration
- Water vapour permeable
- Surface strengthening
For more details please download the product data sheet from the 'DATASHEETS' tab above.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- Typical Coverage (per coat)
- 0.10 - 0.15 kg per m²
- Touch Dry
- Minimum 8 hours
- Brush, Roller, Spray
Be the first to ask a question about this product!
Sikagard 552 W Aquaprimer is one component water dispersed adhesion promoting primer for water dispersed polymer paint coatings. Sikagard 552 W Aquaprimer is part of a system that complies with the requirements of EN 1504-2 as protective coating. Priming coat for concrete and dense mineral substrates like fibre cement, aerated concrete, gypsum and...
Sika Primer 215 is a low viscosity primer that should be used to prime various plastics, timber and other porous materials prior to bonding with Sikaflex products. Because plastics vary so much in their chemical composition, preliminary trials are necessary.
Coo-Var Acrylic Primer Sealer Undercoat is a water-based, low odour primer ideal for plaster preparation or any wood surface which requires priming inside or out. ADVANTAGES Fast drying Exterior/Interior use Matt finish Four tin sizes Apply with roller, brush or spray
Rust-Oleum 3333 Super Adhesion Primer provides excellent adhesion on non-porous, dense mineral substrates like: Tiles or power floated concrete Non-ferrous metals like stainless steel, aluminium or new hot-dip galvanized steel Thermosetting plastics like fibreglass-reinforced polyester or epoxy Perfect chemical bond without blasting or...
An ideal primer for tile and melamine surfaces prior to painting in kitchens and bathrooms or other tiled surfaces. Most paints will adhere to this primer, water or oil based.
A reinforcement fleece for the first coat of Murfill Waterproofing Coating on structural surfaces where required. When fleece is introduced it offers maximum durability, flexibility and strength to the system.
Sikalastic 810 is a two part, polyurethane adhesion promoting bonding bridge for overlapping or overcoating of Sikalastic waterproofing membranes when exceeding the maximum waiting time.
Zinsser Bulls Eye 1-2-3 is a water-based all surface, all purpose primer, sealer & stainkiller. Like Bulls Eye 1-2-3 Plus, it offers fast drying times; dries in 30 minutes, recoatable in 1 hour, and can be used internally or externally, Zinsser Bulls Eye 1-2-3 is particularly effective as an adhesion promoting primer for hard-to-stick...
Eagle Quick-Drying Bitumen Primer provides a key on substrates for all bituminous roof paints and surface coatings, applying by brush or sprayer, and requires no thinning. Use on substrates and surfaces that include: Concrete roofs and floors, cementicious screeds and renders Bitumen felt, asphalt and mastic Weathered corrugated iron and...