"

Bedec Multi Surface Paint

Bedec Multi Surface Paint View larger
Typical Coverage (per coat)12-14m² per litre
Touch Dry2 Hours
ApplicationBrush, Roller, Spray
The figures stated above are approximate. Please ensure you refer to all datasheets for full application information.

Bedec Multi Surface Paint is ideal as a decorative, protective coating for most building surfaces such as concrete, brickwork, rendering, asbestos, asphalt, bitumen, iron, steel, aluminium, lead, zinc, copper, timber, slate, galvanising without the need for etch primer and most plastics, weathered plastic coated cladding and rubberised surfaces after suitable preparation.

Read Full Description

More details

£15.62 + VAT

Bedec Multi Surface Paint is ideal as a decorative, protective coating for most building surfaces such as concrete, brickwork, rendering, asbestos, asphalt, bitumen, iron, steel, aluminium, lead, zinc, copper, timber, slate, galvanising without the need for etch primer and most plastics, weathered plastic coated cladding and rubberised surfaces after suitable preparation.

Bedec Multi Surface Paint is a tried and tested water based paint that resists flaking or peeling because of its outstanding flexibility. It will go over most other paints and varnishes including weathered Tar Varnish, Bitumen and Creosote. It is available in matt, satin and gloss finishes (see colour chart for options), it is non-yellowing and cleans up with water.

Features & Benefits

  • Water based
  • Low VOC
  • Environmentally friendly
  • Quick drying
  • Micro-porous
  • Low odour
  • No primer required
  • No undercoat required

Send us your question

Question

can i paint sapele hardwood windows with multi surface paint. they are bare wood .

RICHARD from carlisle (uk) - 30/11/16

Answer

To ensure no staining or bleed through from the timber, first apply 2 coats of Bedec Stain Block followed by 2 coats of Bedec Multi Surface Paint in the desired colour and finish.

Can I paint my front and rear GRP composite doors with Bedec MSP. The doors have a raised grain finish and the glazing beads are PVC ?

Bill Bell from Sunderland (UK) - 26/10/16

Yes, surfaces to be painted should be thoroughly cleaned down with a liquid detergent solution, rinsed with clean water and allowed to dry. Then rub down with abrasive paper or equivalent, remove any dust and debris and apply 2 coats of Bedec Multi Surface Paint directly to the prepared surface.

Can I paint my front and rear GRP composite doors with Bedec MSP. The doors have a raised grain finish and the glazing beads are PVC ?

Bill Bell from Sunderland (UK) - 26/10/16

Yes, surfaces to be painted should be thoroughly cleaned down with a liquid detergent solution, rinsed with clean water and allowed to dry. Then rub down with abrasive paper or equivalent, remove any dust and debris and apply 2 coats of Bedec Multi Surface Paint directly to the prepared surface.

Can I spray (MSP) gloss finish straight on MDF panels without using primer or undercoat?

Colin liddell from Gloucester (England) - 09/10/16

Yes, thin the first coat with 30% water and allow to dry for 4 hours at 18°C/65% RH.. Then apply 1 or 2 further coats undiluted as required.

I want to paint over plastic wall panels in my bathroom can I use Bedec multi surface paint? Thanks

Hazel Minnican from Carlisle (Uk) - 02/09/16

Yes. Clean the plastic surfaces, lightly abrade with some fine sandpaper and apply 2 coats of Bedec Multi Surface Paint directly to the surface in your desired colour and finish.

Bedec Multi Surface Paint should not be used in any areas subject to water contact such as sinks, baths, shower enclosures, etc.

Hello, Is it possible to paint Formica work tops. Thanks. Anne

Anne from Durham (UK) - 20/08/16

No, but you can use our Rust-Oleum Worktop Transformation Kit.

Does Bedec gloss require sanding between coats?

Maurice from Sherigham (England) - 19/05/16

No, we recommend the surface is sanded prior to application but you do not need to sand between coats unless you wish to 'denib' for a smoother finish.

I have painted over an old gloss painted wooden dining table and chairs with MSP soft Matt . I want to know if when I clean the table with kitchen cleaner will it effect the paint or can I varnish the table to protect the Matt finish and what Matt varnish would you reccommend?

Toni from London (UK) - 04/04/16

We would recommend protecting the surface with Bedec Acrylic Varnish which is available in matt, satin or gloss finishes.

How much thinning is required to spray with compressed air please?

rick parrott from Grimsby (England) - 23/02/16

Bedec Multi Surface Paint can be sprayed un-thinned with HVLP or Airless spray units, if you wish to use air assisted spray then the level of thinning would depend on the pressure, tip size, method of spray, etc. You can thin the product up to 30% with clean, cold water to achieve the desired consistency for your spray set up.

Can Bedec Multi Surface Paint be used on GRP garage doors? If so does it need special preparation please?

Stuart Pritchard from Dorking (UK) - 22/02/16

Yes it can be applied to GRP, the surfaces to be painted should be thoroughly cleaned down with a liquid detergent solution, rinsed with clean water and allowed to dry. Then rub down with abrasive paper or equivalent, remove any dust and debris and apply 2 coats of Bedec Multi Surface Paint directly to the prepared surface.

Can the multi surface paint be used on the inside of a bath?

William hoven from London (England) - 16/02/16

Definitely not, we do however offer Rust-Oleum Tub & Tile Refinishing Kit which can be used to re-paint the interior and exterior of baths.

Can Bedec Multi Surface Paint be used successfully on (oak effect) upvc window frames that are south facing?

Serendiipity from Warrington (UK) - 02/02/16

Yes, the UPVC should be thoroughly cleaned and rubbed down with abrasive paper or equivalent to provide a key for the paint to stick to before two full coats of Bedec Multi Surface Paint are applied.

Is the Bedec Multi Surface Paint suitable to go straight on lead flashing? If so how many coats will be needed.

lee johnson from beverley (uk) - 16/10/15

Yes it is as long as the lead has been weathered for more than 12 months. 2 coats would be required.

Can I use Bedec Multi Surface Paint on tanalised wood?

Paul from London (Uk) - 07/08/15

No, but you can use Zinsser AllCoat Exterior (gloss or satin finish) as long as you prime the timber first with Zinsser Cover Stain.

Can I use Bedec Multi Surface Paint with Owatrol Floetrol? I need to paint a large number of mdf shelves white and want as smooth a finish as possible.

Jonathan Merrison from LONDON (UK) - 13/07/15

Yes, Owatrol Floetrol is compatible with Bedec Multi Surface Paint but we recommend not adding more than 10%.

Can I get Bedec Multi Surface Paint in BS 16 E 53?

Lindsay mungin from Greenock (Scotland) - 25/06/15

Yes. We can mix Bedec Multi Surface Paint to most RAL, BS and NCS colours. Please call our sales team to order 0113 2455450.

Will Bedec Multi Surface Paint be effective on plastic garden furniture?

A Edwards from Crawley (England) - 12/05/15

Yes. Clean the plastic surfaces, lightly abrade with some fine sandpaper and apply 2 coats of Bedec Multi Surface Paint directly to the surface in your desired colour and finish.

Question about the product

I have read and agree to the Conditions of Use (read) Send

The question has been correctly sent

Free delivery on orders over £75 (terms & conditions)

• Deliveries will be made within 3 working days (standard delivery)
• You must be UK mainland based for the free delivery offer.
• Postcodes listed are excluded from the free delivery and priced below.

Please note: deliveries will need to be signed for at the point of delivery.

UK Mainland OnlyUp to £75.00£75.01 +
Standard (2/3 working days)£8.00FREE
Next Day£15.00£15.00
Next day before 09:00am£30.00£30.00
Next day before 10:30am£25.00£25.00
Next day before 12:00pm£20.00£20.00
Saturday Delivery£35.00£35.00














£25 (Standard 2-3 Day Delivery Only)

AB30, AB31, AB32, AB33, AB34, AB35, AB36, AB37, AB38, AB44, AB45, AB46, AB47, AB48, AB49, AB50, AB51, AB52, AB53, AB54, AB55, AB56, FK, G83, IV, KW1, KW2, KW3, KW4, KW5, KW6, KW7, KW8, KW9, KW10, KW11, KW12, KW13, KW14, PA, PH, HS, KA27, KA28, ZE

£35 (Standard 2-3 Day Delivery Only)

BT, IM

£50 (Standard 2-3 Day Delivery Only)

JE, GY

Please note that all carriage prices are quoted without V.A.T. at the current rate.

Scottish Islands - outside standard distribution area, please contact us for a quote.

There may be an exception for heavy goods when purchased in quantity where we will contact you to advise any additional charges.

Next Day delivery and Saturday Service is available on stocked items for orders received before 11:00am only.

Because of the nature of our products, we use specially selected carriers to ensure safe and prompt delivery to you.

Please note: Any time or date named by Rawlins Paints Limited for delivery is given and intended as an estimate only and Rawlins Paints Limited shall not be liable to make good any damage or loss whether arising directly or indirectly out of a delay in delivery. Deliveries are made using a reliable nationwide carrier. Although over 99% of consignments arrive on time, we recommend that no labour is employed to undertake work until materials have arrived on site.

Bedec MSP MSDS

Download

Bedec MSP TDS (NEW)

Download

Bedec MSP Leaflet

Download