"

Zinsser Peel Stop

Zinsser Peel Stop View larger
Typical Coverage (per coat)7.4-9.8m² per litre
Touch Dry1 Hour
ApplicationBrush, Roller, Spray
The figures stated above are approximate. Please ensure you refer to all datasheets for full application information.

Zinsser Peel Stop is a clear, flexible bridging sealer for surfaces where peeling, flaking, dusting or chalking is a problem. Use indoors or out to form a breathable membrane over questionable or faulty substrates. It tightly bonds to old paint and problem areas forming a sound surface for new paint. Its tough acrylic film stays flexible and helps prevent peeling by letting moisture escape.

Read Full Description

More details

£8.35 + VAT

Zinsser Peel Stop is a clear, flexible, binding primer designed for surfaces that are peeling, chalking, or cracking. Even after painted surfaces have been scraped and sanded, tiny cracks and gaps remain under the edges of old paint. Zinsser Peel Stop seeps into these spaces and ‘glues’ them down, forming a tight bond that helps stop future peeling. The special formula of penetrates and binds chalky residues. Applied over cracked or crazed surfaces, Zinsser Peel Stop acts as a flexible bridging primer to seal crazing and prevent the finish coat from cracking, providing a sound surface for primer and paint.

Recommended for application to problem interior / exterior painted surfaces that exhibit chalking, alligatoring, cracking, flaking, and peeling.

Features & Benefits

  • Glues down edges of old coatings
  • Seals and bridges cracking and crazing
  • Binds chalky surfaces
  • Flexible and breathable
  • Recoat in 2 hours
  • Soap and water cleanup

Zinsser Peel Stop is recommended for application to the following substrates:

  • Exterior Surfaces – Previously painted wood siding, windows, doors, fences, and trim; dry and denatured timber; metal gutters and downspouts; masonry siding, walls and foundations (inc. cured concrete, stucco, concrete block, brick, vinyl and galvanised siding, etc.)
  • Interior Surfaces – Previously painted drywall, plaster, cement, concrete, or stucco walls and ceilings; wood doors, windows, baseboards and trim.

Surface Preparation
Thorough surface preparation is very important. Surfaces should be clean, dry, sound and free of dust, dirt, grime, grease, oil, wax, mould, wallpaper adhesive, or any contamination that may interfere with adhesion. If unsure, always wash surface with an appropriate cleaning solution or solvent. Surfaces must be thoroughly scraped and sanded to remove all poorly adhered paint. Lightly sand exposed wood to remove loose fragments. Dull glossy painted areas with sandpaper.

Application
Spot prime areas where paint has been scraped or sanded off. In most cases only one coat is necessary. Excessively porous surfaces may require a second coat.

Shake or stir well before using. Do not thin. Apply with brush and/or roller or airless sprayer. Back brush or roll to work Zinsser Peel Stop into cracks and edges of old paint. Proper application of Zinsser Peel Stop will dry to a slight sheen. Apply a second coat if dull spots appear. For best brushing performance use quality synthetic bristle brushes (natural bristle brushes are not recommended).

Application Conditions
Apply when air and surface temperatures are between 10° and 32°C and humidity is less than 80%. Lower temperatures and higher humidity can prolong drying time. If conditions do not permit prompt drying, allow Zinsser Peel Stop to dry overnight before priming or painting. Do not apply if rain is expected and primer or topcoat cannot be applied before rain occurs.

Priming & Top Coating
Any water based or alkyd primer or paint may be used over Zinsser Peel Stop. As Peel Stop is clear, we recommend priming with Zinsser Bulls Eye 1-2-3 or Zinsser Cover Stain, followed by a coat of quality water based or alkyd paint to assure optimum results.

Notes

  • Zinsser Peel Stop is formulated to help prolong the adhesion of existing paint coatings and is not intended as a substitute for proper surface preparation or for use on surfaces where paint failure results from chronic or excessive moisture intrusion.
  • Repair any source of moisture intrusion before attempting to repaint.
  • Ongoing paint failure may require complete removal of the existing coating system.
  • Not for use on floors, exterior decks or surfaces subject to immersion or prolonged contact with water.

Send us your question

Question

Can I use Zinsser Peel Stop as a stabiliser before applying Sandtex Masonry Paint? I've scraped off bubbling paint etc but I am concerned about stopping paint edges peeling and chalky patches.

Gordon from Birmingham (UK) - 01/08/15

Answer

Yes absolutely, Zinsser Peel Stop can be overcoated with most types of paint so any water based or solvent based Sandtex Paint will be fine.

Question about the product

I have read and agree to the Conditions of Use (read) Send

The question has been correctly sent

Free delivery on orders over £75 (terms & conditions)

• Deliveries will be made within 3 working days (standard delivery)
• You must be UK mainland based for the free delivery offer.
• Postcodes listed are excluded from the free delivery and priced below.

Please note: deliveries will need to be signed for at the point of delivery.

UK Mainland OnlyUp to £75.00£75.01 +
Standard (2/3 working days)£8.00FREE
Next Day£15.00£15.00
Next day before 09:00am£30.00£30.00
Next day before 10:30am£25.00£25.00
Next day before 12:00pm£20.00£20.00
Saturday Delivery£35.00£35.00














£25 (Standard 2-3 Day Delivery Only)

AB30, AB31, AB32, AB33, AB34, AB35, AB36, AB37, AB38, AB44, AB45, AB46, AB47, AB48, AB49, AB50, AB51, AB52, AB53, AB54, AB55, AB56, FK, G83, IV, KW1, KW2, KW3, KW4, KW5, KW6, KW7, KW8, KW9, KW10, KW11, KW12, KW13, KW14, PA, PH, HS, KA27, KA28, ZE

£35 (Standard 2-3 Day Delivery Only)

BT, IM

£50 (Standard 2-3 Day Delivery Only)

JE, GY

Please note that all carriage prices are quoted without V.A.T. at the current rate.

Scottish Islands - outside standard distribution area, please contact us for a quote.

There may be an exception for heavy goods when purchased in quantity where we will contact you to advise any additional charges.

Next Day delivery and Saturday Service is available on stocked items for orders received before 11:00am only.

Because of the nature of our products, we use specially selected carriers to ensure safe and prompt delivery to you.

Please note: Any time or date named by Rawlins Paints Limited for delivery is given and intended as an estimate only and Rawlins Paints Limited shall not be liable to make good any damage or loss whether arising directly or indirectly out of a delay in delivery. Deliveries are made using a reliable nationwide carrier. Although over 99% of consignments arrive on time, we recommend that no labour is employed to undertake work until materials have arrived on site.

Peel Stop Brochure

Download

Zinsser Peel Stop TDS

Download

Zinsser Peel Stop MSDS

Download