Rust-Oleum 5160 Flexible Joint Filler
Rust-Oleum 5160 Flexible Joint Filler is a pourable flexible polyurethane joint filler with excellent wear and chemical resistance for expansion joints and other floor joints. Remains flexible, quick curing, indoor and outdoor use, low odour and heavy duty.
Rust-Oleum 5160 Flexible Joint Filler is a pourable flexible polyurethane joint filler with excellent wear and chemical resistance for expansion joints and other floor joints.
Features & Benefits
- Remains flexible to allow the floor to expand and collapse
- Quickly back into service; sealed joints accept traffic after 8-12 hours
- withstands heavy traffic and many chemicals
- For indoor and outdoor use
- Low odour
Ensure the sides of the joint are clean and dry. Any damage joint edges should be repaired with Rust-Oleum 5180 Epoxy Repair Mortar. Mix the 2 components of Rust-Oleum 5160 Flexible Joint Filler together thoroughly for at least 3 minutes until homogenous before use.
For joints 5-10mm wide, depth should be equal to width. For joints 10-20mm wide, depth should be 10mm. For joints over 20mm wide, depth should be half the width. Rust-Oleum 5160 Flexible Joint Filler may be poured - To facilitate this, crimp the rim of the tin and pour evenly into the prepared joint, leaving the top of the sealant just below the level of the floor. Remove any remaining air bubbles by running a flat blade across the surface. Rust-Oleum 5160 Flexible Joint Rods should be used to reduce deeper joints to the desired depth. Use Rust-Oleum 5161 Flexible Joint Primer to improve adhesion.
The working life of the mixed product is one hour depending on temperature. Cleanup: Rust-Oleum Thinner 160.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
|Typical Coverage (per coat)||10m per litre with a joint of 10mm depth and 10mm width|
|Touch Dry||2 Hours|
|The figures stated above are approximate. Please ensure you refer to all datasheets for full application information.|
Be the first to ask a question about this product!
Colour reproduction of the Products on the Site is limited by the technology used to deliver web pages and by the colour representation of Customer’s own monitor and computer set-up. We have made every effort to display as accurately as possible the colours of our Products but we cannot guarantee that the colour shown on Customer’s monitor’s display will accurately reflect the colour of the Product on delivery. We recommend that Customer first purchases the smallest Product available or access an industry standard colour chart in person (and not digitally) to ensure that the colour is acceptable for its purposes. For more information, please see our Terms & Conditions of Sale.Close