SikaLevel 30 Latex Ultra
SikaLevel 30 Latex Ultra is a high strength rapid setting cement based powder, which when mixed with water, can be used to level out uneven floors and screeds. It may be overlaid with common floor coverings or may be left as a final wearing surface and can be applied in one coat from 2-10mm in depth (25mm when filled).
SikaLevel 30 Latex Ultra is a high strength rapid setting cement based powder, which when mixed with water, can be used to level out uneven floors and screeds. SikaLevel 30 Latex Ultra may be overlaid with common floor coverings or may be left as a final wearing surface. SikaLevel 30 Latex Ultra will even accept light vehicular traffic and may be applied in one coat from 2-10mm in depth (25mm when filled).
Typical surfaces include concrete and screeding, existing unglazed ceramic tiles, brick, stone etc. When mixed as directed, the compound provides a free flowing mix that may be walked on in 2 hours and can be overlaid with ceramic tiles after only 3 hours at normal temperatures. NOTE: when overlaying with other floor coverings allow 24 hours drying time for each 10mm depth. Tested to EN13813 Class CT – C30-F7-AR 0.5.
Features & Benefits
- Fast setting, foot trafficable within 2 hours, can be tiled within 3 hours
- Interior & exterior use
- Can withstand vehicular traffic
- Final wearing coat, Overpaintable
- Water and frost resistant
- Application depth 2-10mm
- Tested to EN13813 Class CT – C30-F7-AR 0.5
Areas For Use
- Wooden flooring
- Floating floors
- Floors with underfloor heating
- Sand/cement screeds (not anhydrite), concrete slabs and pre-cast elements.
- Existing ceramic and rigid plastic tiles.
For more details please download the product data sheet from the 'DATASHEETS' tab above.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
|The figures stated above are approximate. Please ensure you refer to all datasheets for full application information.|
Be the first to ask a question about this product!
Colour reproduction of the Products on the Site is limited by the technology used to deliver web pages and by the colour representation of Customer’s own monitor and computer set-up. We have made every effort to display as accurately as possible the colours of our Products but we cannot guarantee that the colour shown on Customer’s monitor’s display will accurately reflect the colour of the Product on delivery. We recommend that Customer first purchases the smallest Product available or access an industry standard colour chart in person (and not digitally) to ensure that the colour is acceptable for its purposes. For more information, please see our Terms & Conditions of Sale.Close