Bullet Roof Mega Mastic can bond, seal and fill almost anything without a primer, even when wet or fully submerged. This unique Bullet Roof hybrid polymer formulation contains no solvents, and has virtually no odour.
Bullet Roof Mega Mastic is a paintable sealant that has been specifically formulated to seal typical joints where a strong bond and high movement is required. Due to the solvent-free nauture of Bullet Roof Mega Mastic, it can be used in areas where highly solvented or harmful sealants are not allowed.
Excellent adhesion to PVC-U coated metals, brickwork, slate, tile, lead, steel, aluminium, zinc, copper, brass, stainless steel, glass, polycarbonate and polyester. Additionally, Mega Mastic boasts permanent elastic sealing with high adhesive strength to a wide variety of substrates including wood, concrete, tiles, steel, aluminium, zinc, copper, brass, stainless steel, glass and polyester.
Top Features & Benefits
-
Premium quality high modulus sealant that can often be used in wet applications.
-
Neutral system, free from isocyanates and silicones.
-
Non staining, odour free and bubble free curing.
-
Good movement accommodation. Adhesive sealing and joining to most substrates.
-
Highly resistant to ageing and weathering. Paintable (testing is recommended).
- Resistant to water, salt water, grease oils, fuels, defrosting liquids, detergents, aliphatic fats, mildew, weak acids and alkali.
Preparation & Application
Preparation
All surfaces must be clean, dry and free from frost, grease and loose materials.Apply primer if required. Install bond breaker to prevent bond at base of joint where necessary. Most substrates only require priming if testing indicates a need or where sealant will be subjected to water immersion afer cure.
Cut the top of the screw thread off the cartridge and screw on the nozzle. Cut nozzle to correct diameter for joint size. Apply using a skeleton or powered gun into the joint ensuring good contact with surfaces. In deep joints, the use of a backing rod is essential to ensure food joint formation.
In situations where and especially neat finish is required, use masking tape to cover the face edges of the joint and remove immediately once tooling has been completed.
Application
Apply between 0°C to 30°C. Cures at a rate of 2-3mm in 24 hours at 23°C @ 50% RH. Lower conditions will result in a slower rate of cure.
Tooling
Tool immediately after sealant has been applied within the working time of the product.
Notes
Not suitable for glazing applications, marble, natual stone, aquaria construction or in joints deeper than 15mm.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.