Teamac Acrylic Roof Coating, is a fast drying, water based coating that dries to a low sheen finish. It's a cost-effective product to protect, refresh and decorate tile and brick roofs as well as sealing asbestos sheets and barns.
7 to 12 m²/litre @ 35 microns D.F.T depending on porosity.
The practical spreading rate may be lower as this depends on factors such as the porosity and roughness of the surface to be painted and material losses during application.
Drying Times
Drying Times At 20°C/RH 50%
Touch Dry:
2 Hours
Dry To Handle:
12 Hours
Dry To Recoat:
12 hours or overnight
Fully Cured:
3 - 5 Days
Low temperature and high humidity will adversely affect application, drying and performance of any coating.
Surface Preparation
Ensure all surfaces are clean, dry and free from grease, oil and any other contaminates.
Preceeding Coat
N/A
Mixing
Mix well before use.
Application Conditions
Do not apply below 10°C. Cold and damp conditions will prolong drying times.
As dictated by normal good painting practice.
In confined spaces, provide adequate ventilation during application and drying.
Application Methods
Method
Airless Spray
Conventional Spray
Brush
Roller
No
No
Yes
Yes
Thinner (Max vol): Clean Water (10%)
Nozzle Size: N/A
Nozzle Pressure: N/A
Cleaning Solvent: Clean Water
Health & Safety
See safety data sheet - SDS 10642 in attatchments section above.
Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.
I have a garage roof with some white asbestos (Been tested) - what would you recommend on products to seal the roof rather than have the asbestos removed.
Question: Is this suitable for an corrugated asbestos sloping roof? Does it require any jointing tape? Existing roof been de-mossed. Does product require anti fungal solution before application?
Answer from Rawlins’ Technical Team:
Teamac Acrylic Coating is suitable for corrugated asbestos, it will seal and colour the asbestos but it is not a full waterproofing system so any damages to the asbestos, joints, fixings, etc. would have to be repaired to make the roof watertight prior to coating. The roof surface does need to be clean prior to application of the Teamac Acrylic Coating (contact us for guidance on cleaning asbestos if requried) and a fungicidal solution to treat and wash the roof with like Rust-Oleum Mathys AMW Fungicidal Wash is always good practice.
Tom Korn on 2016-03-15 21:47:04
Question: Can I use Teamac coating on existing sound but worn bitumen sheeting.
Answer from Rawlins’ Technical Team:
Yes, it should be fine to use on this but we would recommend a test is done for adhesion before applying the coating to the entire area. The more weathered the sheeting is the better, as this should mean it will be more porous and provide better adhesion.
John Ravenhill on 2016-03-07 15:17:42
Question:
Is teamac acrylic coating ok to use on the under side of a ribbed asbestos roof?
Answer from Rawlins’ Technical Team:
Yes, it can be applied directly in two coats after cleaning. Be sure to follow government and local authoriy guidelines - further information on this can be provided by our Technical Department upon request.
Teamac Acrylic Roof Coating is only available with the shipping and delivery timescales listed below - please do not contact our Customer Support Team with enquiries about alternative or earlier shipping and delivery times.
Saturdays and Sundays, as well as Bank Holidays, are not classed as working days.
Orders placed after the cut-off for this product will not be processed for earliest dispatch until 9am the next working day.
General Painting Application Kit from Rawlins Paints provides the basics for any painting project. Whether it is a one off job, or you just want to make sure the right application tools get to site.
Provides an economical way of making sure you will have what you need
Ideal for interior and exterior paint projects
Click to jump down to...