GacoFlex 66S Tape is a low profile, fusion-bonded polyester fiber designed to form a strong, yet conforming, membrane for silicone elastomeric coatings on uneven surfaces. Used for plywood joints, concrete construction joints, concrete cracks, and joints between metal, fiberglass or insulation, and combinations of the above substrates in roof,...
Gaco Liquid Roof Tape
Gaco Liquid Roof Tape is a thick, high-build, rubber-like liquid comprised of 100% silicone and microfibers. The unique properties allow it to replace traditional rubber and mesh seam tape when used in conjunction with GacoPro Roof Coating.
Gaco Liquid Roof Tape is a thick, high-build, rubber-like liquid comprised of 100% silicone and microfibres. The unique properties allow it to replace traditional rubber and mesh seam tape when used in conjunction with GacoPro Roof Coating.
Gaco Liquid Roof Tape provides a seamless repair solution for joints, flashings, fasteners, small cracks, vents, drains, seams, uneven surfaces, protrusions, depressions and transitions. It will exhibit resistance to wear under light foot traffic. GacoPro Liquid Roof Tape will bond to aged asphalt, aged EPDM, aged TPO/CPA, built-up, cap sheet, composite, concrete, fibreglass, metal, modified bitumen, tar and gravel, torch down, sprayed polyurethane foam and most existing coatings on flat or sloped roofs.
Feaures & Benefits
- Provides a seamless surface for GacoPro Roof Coating
- Highly resistant to UV rays, ponding water and temperature extremes
- Excellent for light traffic areas
Ensure Gaco Liquid Roof Tape overlaps all applied areas by at least 50mm in all directions at approximately 3mm thickness. This provides a coverage rate of 11.5 linear metres per 3.8lt can with a 100mm wide band. Alternatively, a 3.8lt can of product will cover approximately 350 fasteners based on 50mm patches at 3mm thickness. Coverage rate may vary with the type of application and texture of the substrate.
Please contact Rawlins Paints' Technical Support Team on 0113 2455450 for more information.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
Be the first to ask a question about this product!
Tor Elastascrim FT (SS6000140) is a non-flammable, semi-elastic, putty-like butyl rubber based strip encapsulant/sealant. Supplied in roll form on siliconised paper release backing for use as a formable pre-coat encapsulant and sealant over roof sheet bolts etc. Also usable as a lap joint gap filler/sealer on sheeted (profile metal, fibre-cement etc)...
Tor Elastaseal FIA (Foaming Insulation Adhesive) is a fast curing polyurethane based aerosol foaming adhesive, applied by special aerosol gun, it meets Fire Class B1. Elastaseal FIA should be used for the bonding of roofing insulation boards to roofing substrates and membranes including asphalt, felt, vapour control layers, aged single ply membranes, etc.
Tor Elastamat HD (SS6000225) is a random weave chopped strand glass fibre mat for high strength reinforcement of Tor liquid applied roof waterproofing systems. It is used as a full reinforcement on heavy duty flat roof applications and where ponding is evident, and as localised or partial reinforcement in other areas.
Rust-Oleum Dacfill SB Primer is a stabilising sealer and primer for use on a wide range of substrates. It is a single component, moisture-curing solvent-based polyurethane resin solution to be used as a surface stabiliser/adhesion promoter for degraded felts, asphalt etc. and porous mineral substrates.
Protection with Dacfill glassfibre reinforcement fleece provides additional mechanical strength and is very easy to apply. Recommended uses are for the reinforcement of the first coat of Dacfill or Dacfill HZ.
Eagle Wet Primer is a solvent-free resin with low viscosity, applying in a single layer to increase adherence of waterproofing systems - use with Desmopol membranes, even on concrete or mortar substrates with high residual moisture.
Tor Elastaseal Z Embedment Coat (RC140) is a cold applied single pack, ultra high solids moisture activated elastomeric urethane coating free from solvent odour. For application in conjunction with Elastamat glass fibre reinforcement as the basecoat in Elastaseal Z roof waterproofing membrane systems. A high build, heavy duty coating, providing durable,...
Tor Elastascrim BT is a non-flammable, butyl, rubber based, self-adhesive tape with a polymeric textile reinforcement protection fleece. Used for the bridging of roof sheet lap joints, stabilised cracks, movement joints, small gaps, abutment details etc, prior to application of Tor roof waterproofing and protective coating systems etc.
Eagle Anti-Slip Slate Grit applies to a fully cured roof to provide a non-slip surface for heavily trafficked areas. Use with Desmopol, Ultraflex or a relevant top coat. Coverage rate approx. 25-30M2 per 10Kg
Eagle Quick-Drying Bitumen Primer provides a key on substrates for all bituminous roof paints and surface coatings, applying by brush or sprayer, and requires no thinning. Use on substrates and surfaces that include: Concrete roofs and floors, cementicious screeds and renders Bitumen felt, asphalt and mastic Weathered corrugated iron and...
An epoxy primer excellent anti-corrosion properties this primer is the perfect choice for steel and iron gutters or any other steel/iron surface. Top Features Good anti-corrosion properties Brush or airless spray applicable Application temperature from +5℃ (substrate)
Sika MultiSeal BT is a self-adhesive sealing tape made of a butyl rubber compound, protected by a reinforced aluminium metal film. Used for sealing and repairing against water penetration on roofs including sheet metal work, facades, broken roof tiles, leaking roof gutters, chimneys and roof lights, air conditioning piping, caravans and trailers, office...
Everbuild 902 Bitumen & Flashing Primer is a thin black primer used to give a key prior to applying bitumen paints and roof coatings such as Everbuild 901 Black Bitumen Paint, Everbuild 905 All Weather Roof Coating and Everbuild 906 Bitumen Roofing Emulsion.
Torprufe FS Primer (RC253) is a stabilising and bonding primer for use on new and weathered smooth bitumen based felts prior to application of Tor water based roof coatings (Torprufe CRC, Elastaseal WB etc). May also be suitable (subject to test) over synthetic carrier membranes. Also as a substrate bonding primer for installation of TorVap VCL / CM in...