Eagle Wet Primer is a solvent-free resin with low viscosity, applying in a single layer to increase adherence of waterproofing systems - use with Desmopol membranes, even on concrete or mortar substrates with high residual moisture.
Tor Elastamat Regular
Tor Elastamat Regular (SS6000116 / SS6000025RL / SS6000830) is a random weave chopped strand glass fibre mat (nominal 100g/m²) for the reinforcement of Tor liquid applied roof waterproofing systems. It is used as a full reinforcement on flat roof applications and where ponding is evident, and as localised or partial reinforcement in other areas.
Tor Elastamat Regular (SS6000116 / SS6000025RL / SS6000830) is a random weave chopped strand glass fibre mat (nominal 100g/m²) for the reinforcement of Tor liquid applied roof waterproofing systems. It is used as a full reinforcement on flat roof applications and where ponding is evident, and as localised or partial reinforcement in other areas. It helps to provide the ideal solution for areas subject to movement and damage, especially around upstands, joints, etc.
The random nature of the weave allows the fibres to be easily incorporated within the roof coating and be moulded easily to rough and irregular surfaces. When encapsulated, the fibres help provide greater tensile strength and tear resistance to the roof coating system, whilst retaining its inherent flexibility.
Preparation & Application
Side laps, hairline and associated cracks, bolt heads, joints, movement joints, stepped joints and dissimilar adjoining substrates: Apply 1 coat of the roof coating to a minimum width of 75mm either side of the item. Whilst wet insert Tor Elastamat Regular and thoroughly “wet-in”.
Upstands, detailing, protrusions, etc: Apply 1 coat of the roof coating to a minimum width of 150mm. Whilst wet insert Tor Elastamat Regular and thoroughly “wet-in”.
Apply 1 coat of the roof coating. Whilst wet insert Tor Elastamat Regular and thoroughly “wet-in”. Overlap adjacent reinforcement areas already laid by at least 50mm ensuring sufficient extra embedment material is applied to these areas.
When embedding Tor Elastamat Regular it may be necessary to tamp the mat. If so, use a short bristled brush or specialist roller ensuring that there are no tented areas. Immediately after embedding check for any upstanding glass fibre strands and lay smooth.
- Standard 100 gram reinforcing mat (1.25m x 80m) - SS6000116
- Small pack 100 gram reinforcing mat (1m x 25m) - SS6000025IRL
- 100 gram edge detail mat (0.4m x 50m) - SS6000830
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
Be the first to ask a question about this product!
Bullet Roof GRP Roofing Resin is a high grade GRP resin that is not reblended, which allows for the purity Bullet Roof GRP Resin. Top Features Medium reactivity ortho Thixotropic Pre-accelerated Reduced styrene emission
Eagle Preformed Corners (Drip and Non-Drip) for roofs, aiding or restricting water runoff for use in domestic and industrial applications. Available in different configurations to suit all projects - see images below for approximate dimensions.
Tor Elastascrim FT (SS6000140) is a non-flammable, semi-elastic, putty-like butyl rubber based strip encapsulant/sealant. Supplied in roll form on siliconised paper release backing for use as a formable pre-coat encapsulant and sealant over roof sheet bolts etc. Also usable as a lap joint gap filler/sealer on sheeted (profile metal, fibre-cement etc)...
Rust-Oleum Mathys Dacfill / Dacfill HZ Fleece is a polyester woven mesh, flexible and elastic which is specified for use as a system with Dacfill HZ flat-roof coating. Reinforcement fleeces provide added durability, flexibility and strength to flat-roofs.
Everbuild 902 Bitumen & Flashing Primer is a thin black primer used to give a key prior to applying bitumen paints and roof coatings such as Everbuild 901 Black Bitumen Paint, Everbuild 905 All Weather Roof Coating and Everbuild 906 Bitumen Roofing Emulsion.
Tordeck DSP is a super-high solids two pack epoxy resin based primer used for the suppression of vapour pressure effects to prevent air/moisture blistering on suspect concrete and asphalt balcony surfaces, suspended decking etc, prior to application of Tordeck two pack systems. Also used in conjunction with Florex Solvent Free Floor Coating.
Eagle Tecnoplastic Rubber Granules is a plastic bead, applied to a fully cured roof to provide a less harsh, non-slip surface for trafficked areas. Good for barefoot traffic areas Use with Tecnotop 2C Available as a 2Kg tub, covering up to 100M2 (depending on density of the mixture)
The new Tortrim range has been developed to provide detail plastic trims to produce a neat edge to Tor roof systems. Bond It PU18 is a one part moisture curing polyurethane fast grab adhesive/sealant for bonding trim pieces together.
Tor Elastascrim BT is a non-flammable, butyl, rubber based, self-adhesive tape with a polymeric textile reinforcement protection fleece. Used for the bridging of roof sheet lap joints, stabilised cracks, movement joints, small gaps, abutment details etc, prior to application of Tor roof waterproofing and protective coating systems etc.
GacoFlex E5320 2-Part Epoxy Primer/Filler is a two-component, water-based epoxy primer that is ideal for use on most roofing surfaces including metal roofs and flashings. This easy-to-apply primer bonds to properly prepared roofing surfaces and improves adhesion of GacoFlex silicone coatings and other top coats, especially on weathered...
Protection with Dacfill glassfibre reinforcement fleece provides additional mechanical strength and is very easy to apply. Recommended uses are for the reinforcement of the first coat of Dacfill or Dacfill HZ.
Sika MultiSeal is a self-adhesive sealing tape made from bitumen rubber compound, protected by a reinforced aluminium film. Use for general repair to existing flashing, roofs including sheet metal work, facades, broken roof tiles, leaking gutters, duct work, sealing projections through the roof. Very easy to apply, cold applied, self-adhesive, good...
A unique product that enables damp, moist and green concrete to be primed at surface temperatures of +5 degrees and rising saving large amounts of down time. It cures rapidly to from a DPM or damp proof membrane. Top Features VOC close to “0” and water based Forms an effective barrier against negative/back pressure Forms a damp and...
Primer for the Durashield Waterproofing System allowing for priming and topcoat applied in one day. Excellent for felted surfaces, asbestos cement, concrete, weathered asphalt, timber decks, metal and plastisol, among others. Advantages Rubber solvent-based primer Penetrates porous substrates Clear in colour