- There are no more items in your cart
- Shipping Calculated at checkout
- Sub-Total (ex. VAT) £0.00
Tor Damp Surface Primer
We no longer stock this product, but can recommend Watco Epoxy Damp Proof Membrane as a great alternative.
Please note: it is important to check that any alternative product is suitable for your requirements, as our suggestion is given in good faith but without warranty. If you are in any doubt please first contact our technical team on 0113 2455450 (option 2) or send a message to [email protected] where we will be happy to discuss your project.
Tor Damp Surface Primer (Formerly known as Tordeck DSP) is a super-high solids two pack epoxy resin based primer used for the suppression of vapour pressure effects to prevent air/moisture blistering on suspect concrete and asphalt balcony surfaces, suspended decking etc, prior to application of Tordeck two pack systems. Also used in conjunction with Florex Solvent Free Floor Coating.
Tor Damp Surface Primer (Formerly known as Tordeck DSP) is a super-high solids two pack epoxy resin based primer used for the suppression of vapour pressure effects to prevent air/moisture blistering on suspect concrete and asphalt balcony surfaces, suspended decking etc, prior to application of Tordeck two pack systems. Also used in conjunction with Florex Solvent Free Floor Coating.
Surface Preparation
Ensure surfaces are sound, clean, contaminant-free and as dry as possible before coating. Thoroughly scrub down all dirty surfaces with alkaline detergent solution followed by thorough rinsing (alternatively steam clean) and dry off. Remove residual contamination by scraping, surface grinding etc. Mechanically remove any unsound/incompatible coatings. Fully grind or vacu blast bare concrete to give an open sandpaper like surface. Reduce undulations/peaks etc by mechanical abrasion or grinding.
Application
Apply one or two coats as required by roller or squeegee to give an even spread, ensuring good cover on profile peaks etc. Discharge mixed material as soon as possible to maintain workability. Spike roller if necessary to de-aerate coating.
Limitations
- Do not apply to inadequately prepared or unsound surfaces.
- Do not apply at surface temperatures below 8°C or overnight ambient temperatures below 5°C. Low overnight temperatures will further extend minimum overcoating times.
- Overcoating should be carried out within the timescales stated on the product data sheet to promote maximum intercoat adhesion and avoid film defects. Ensure surfaces are clean between coats.
- Substrates with relative humidity of greater than 85% will require two coats of Tordeck DSP.
Data sheet
- Application
- Roller
- Touch Dry
- 6 Hours
Be the first to ask a question about this product!
IMPORTANT SHIPPING & DELIVERY INFORMATION
Tor Damp Surface Primer is only available with the shipping and delivery timescales listed below - please do not contact our Customer Support Team with enquiries about alternative or earlier shipping and delivery times.
Saturdays and Sundays, as well as Bank Holidays, are not classed as working days.
Orders placed after the cut-off for this product will not be processed for earliest dispatch until 9am the next working day.
All delivery costs below are excluding VAT