Blackfriar Professional Solar Reflective Paint White is a specially formulated reflective acrylic coating for reducing solar heat gain on tiles, felt, asphalt, wood, masonry and concrete surfaces. Reflective, textured finish, waterproofs and protects, flexible, resists fungal growth, easy to apply, water based, brush or roller application, can be applied to previously painted surfaces.
Recommended Uses
Preparation
All surfaces should be clean and free of loose material and contamination. Remove all moss, lichen, fungal growth and other contaminants. Scrape off any loose paint. Surfaces can be slightly damp but they should not be wet. Priming is not necessary.
- Roofs - Asbestos/cement roofs can be successfully coated, but may require special preparation to comply with asbestos regulations. All surfaces must be clean and free from loose and dusty matter. Previous coatings should be sound and well bonded.
- Brick and Cementitious Surfaces - Surfaces should be clean, dry and free of any loose material and contamination. Use a fungicide like Blackfriar Anti-Mould Solution or Concentrated Fungicidal Wash to remove any fungi, algae or moss, etc. Scrape off any loose paint. Existing hard smooth, glossy paint should be lightly sanded to provide a key. Wash with a detergent solution, rinse with water and allow to dry. Make good any minor defects with external grade filler. Damp down dry, absorbent surfaces with water to leave them slightly damp.
- Wooden Surfaces - All bare wooden surfaces should be clean and dry. Not recommended for door or window frames. Do not apply to previously painted wood unless all traces of old paint have been removed.
Application
Stir thoroughly before use. Apply with a brush or roller working the paint in any surface imperfections. Two coats recommended. Blackfriar Professional White Solar Reflective Paint is tough and durable but is not suitable for persistent foot or mechanical traffic. It should be applied between 10°C and 30°C. Avoid applying to very hot substrates such as dark surfaces in direct sunlight. Do not apply if rainfall is imminent or if humidity is very high.
Coverage Rate
4-8m²/litre per coat. Two coats recommended.
Drying Time
- 2-4hrs @20°C. Allow to dry for a minimum of 4hrs @20°C between coats.
- Full cure is achieved in 5-7 days @20°C
Clean Up
Remove as much product from application equipment as possible before washing with water. Do not empty into drains or watercourses. Some local authorities have special facilities for the disposal of waste coatings.
Please contact Rawlins Paints' Technical Support Team on 0113 2455450 for more information