HMG Acrythane Fluorescent is a 2K acrylic fluorescent cured with an isocyanate hardener.

This product MUST be purchased/used in conjuction with its manufacturer specified hardener and thinner:

HMG Acrythane Fluorescent is part of a 3 coat system as follows;

Please note more than one coat of each may be required depending on application to achieve desired results.

Click To Jump To Section:

• Features & Benefits
• Product Specification
• Film Thickness Range And Coverage
• Drying Times
• Surface Preparation
• Application Methods
• Product Notes
• Health & Safety

Features & Benefits

• Part two of a three part system.

To be used with suggested primer/filler/sealer systems:

• HMG EpiPrime White
• Polykote 2K MU White Primer
• Cellulose APS White Primer
• Polykote 2K AMC Primer

• Not to be used in connection with 2004/42/CE
• Not to be used under SI2005:27773

Product Specification

Additionl Technical Information:

• The light-fastness of fluorescent pigments (all grades) is between 2 - 3 on the blue wool scale (of 8). This level of colour fastness is increased to 3 - 4 by over-lacquering with a UVRA containing clear varnish or lacquer. Please contact Rawlins Paints for specific recommendations on Tech - 0113 2455450 (option 2) or [email protected] Sales - 0113 2455450 or [email protected] .
• In all environments, fluorescent paints will fade 5 - 10 times faster than conventional industrial, decorative or automotive coatings.
• Signal green suitable for small areas only.

Film Thickness Range And Coverage

Coverage: 14 square metres per litre (Theoretical).

• HMG technical data sheets indicate a dry film thickness that will be achieved when applying a particular wet film thickness.
• These values are a guide only and are not to be used as specifications.
• Film thickness will vary depending on actual use and specification.
• Great care should be taken to achieve the dft stated in the agreed specification and to avoid areas of excessively low or high thickness.

Drying Times

Surface Preparation

• Ensure surfaces to be coated are dry and must be cleaned using the appropriate HMG product to remove all traces of contaminants.
• Read and follow the safety data sheet, product data sheet and label instructions.
• Stir all paints thoroughly before use.
• Always use the same batch number on the same job.
• Check colour & sheen.
• Filter the product immediately before use.
• Reduce emissions and maintain quality by replacing tin lid after use.

Application Methods

For further information on mixing ratios please contact Rawlins Paints on Tech - 0113 2455450 (option 2) or [email protected] Sales - 0113 2455450 or [email protected]

Product Notes

Health & Safety

• Refer to the safety data sheet in the attachments section above and tin label prior to use.

Click to go back to the top of the page