Britannia Anti-Vandal Paint


Britannia Anti-Vandal Paint is a solvent free, non-drying deterrent against vandals and trespassers for use on a wide range of structures.

  • Specially formulated to stay soft and slippery
  • External use
  • For brush or mitt application
  • For use on drain pipes, sills, tops of wall and fences, anywhere which may be used as a grip point to gain unauthorised access
  • One-pack product

£41.38(ex. VAT)
£49.66 (inc. VAT)
Product not available
Last Items in Stock and Available for Delivery (See Delivery Options Below)


Britannia Anti-Vandal Paint is an eco-friendly, soft and slippery non-drying deterrent. For use on drain pipes, sills, tops of walls and fences, anywhere which may be used as a grip point to gain unauthorised access, electricity pylons to prevent access to dangerous areas, telegraph poles, lamp posts to prevent climbing.

Solvent-free and eco-friendly, it deters vandals and trespassers on external surfaces.

Anti Vandal paint is not recommended for use on surfaces in areas which are subject to legitimate daily contact. It is also recommended that it not be applied to sills, fall pipes, walls, etc., within 7 feet of the ground level, and it’s presence should be clearly identified to the public with WARNING NOTICES.

Quick Links - Click To Jump To Section:

Features & Benefits

  • Eco-friendly
  • Soft and slippery non-drying deterrent
  • Deters vandals and trespassers
  • For use on a wide range of structures
  • External use
  • For brush or mitt application
  • One-pack
  • For use on rain pipes, sills, tops of walls and fences, telegraph poles, lamp posts and pylons

Spreading Rate

These will vary depending on substrate, the site conditions and longevity required.

Typically spreading rates will vary depending on the end use.

  • 3-4m2 /lt, this is largely dependent on thickness of coating and substrate to be painted.

Drying Times

  • Non drying system. This product does not dry.



  • New and previously painted surfaces should be dry and free from loose and flaking material, dirt, grease wax, etc.
  • Unpainted woodwork and steelwork should be primed with the appropriate primer.

Metal Surfaces:

  • Remove any loose material such as rust, scale, dirt, etc by thorough wire brushing and prime with a suitable primer prior to application of the Anti Vandal paint.
  • Fats, oils or greases must be removed by mechanical means and detergent washing.

Porous Surfaces:

  • Porous surfaces such as unpainted wood or brickwork should be sealed with a suitable primer/sealer to prevent the product drying out prior to application of the Anti Vandal paint.

Smooth surfaces:

  • Smooth surfaces should be roughened using coarse abrasive paper or by wire brushing prior to application of the Anti Vandal paint.


  • Stir well before use.
  • Please follow the coverage rates shown in Spreading Rate Section.
  • Apply Anti Vandal paint with a short haired brush or industrial mitt, smoothing to a uniform finish to the recommended spreading rate.
  • Must be applied no lower than 7 feet from the ground.
  • Do not thin the product.
  • Wear gloves during application and only apply to areas above arms reach.


  • Clean all equipment with white spirit immediately after use.

Shelf Life & Storage

  • Up to 2 years if stored correctly in an unopened container.


  • Keep out of reach of children.
  • In case of contact with eyes rinse immediately with plenty of water and seek medical advice.
  • Remove splashes from skin with a recognised hand cleaner.
  • To be applied on structures no less than two metres from the floor.
  • Do not use near fishponds.
  • Very toxic to aquatic organisms. May cause long term adverse effects in the aquatic environments.
  • Do not empty into drains.

Product Details

Data sheet

For Use By
General Use
Interior / Exterior Use
For Use On
Metal, Wood, Plastic, Brickwork, Masonry
Application Method
Brush, Mitt
Standard / Ready Mixed
Single, Two or Three Pack
Pack Size
Base Type
Solvent Free
Fastest Delivery
Next Working Day

Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.

questions John shaw on 2022-06-27 11:08:32

Can you use anti vandal paint on a shed foof

Answer from Rawlins’ Technical Team: 

Unfortunately no, this should be used on vertical surfaces, or small horizontal areas such as the tops of walls over the minimum height of 7 feet.

Question about the product

* Required fields