Coo-Var P101 Anti-Graffiti Coating
Coo-Var P101 is a two pack, clear aliphatic polyurethane coating which provides a highly graffiti-resistant finish inside or outside with B.S. Flame Spread Rating.
- Used as clear sealer for porous surfaces prior to the application of Coo-Var GP101 Graffiti & Flyposting Protection System.
- Coo-Var P101 is used in areas of high hygiene, chemical contact and surfaces subject to graffiti attack.
- Ideal for bridges, statues, walls, toilets and more.
- Can be used over compatible water based paints to provide a glaze over a colour.
- Not for use over conventional solvent based paints.
Coo-Var P101 is a two pack, clear aliphatic polyurethane coating which provides a highly graffiti-resistant finish inside or outside with B.S. Flame Spread Rating. Coo-Var P101 is used in areas of high hygiene, chemical contact and surfaces subject to graffiti attack. Is ideal for bridges, statues, walls, toilets and more. Can be used over compatible water-based paints to provide a glaze over a colour. Not for use over conventional solvent based paints.
The product is supplied in two containers: one larger than the other and labelled Base. The other smaller one labelled Hardener. The contents of the pack marked Hardener are added to the contents of the larger pack marked Base and thoroughly mixed together, preferably by slow speed electric mixer for 2 minutes or until thoroughly mixed. Failure to mix the material correctly will lead to uncured areas in the coating.
Apply 5 to 30°C by brush or short nap mohair roller. This product can also be spray applied in approved conditions. When brush or roller applied at ambient temperatures - these
products do not emit free Isocyanate at above levels recommended by C.O.S.H.H. Regulations.
However, the protective measures shown on the product labels and safety data sheets must be followed. When used at elevated temperatures or atomised (sprayed) these products do emit small amounts of free Isocyanate and should only be sprayed in an atmosphere controlled working area, with suitable ventilation or flame proof extraction of air. Operatives must wear suitable protective clothing and separate air fed breathing apparatus. It is recommended that spraying of these products be avoided wherever possible to facilitate uncomplicated application
and site conditions.
Apply directly. Prime porous concrete, plaster and brickwork with Coo-Var High Performance Primer. Ashphalt can only be coated if primer is used first.
Please contact Rawlins Paints' Technical Support Team on 0113 2455450 for more information.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- Interior / Exterior Use
- Interior and Exterior
- Water / Solvent Based
- For Use On
- Concrete, Plaster, Brickwork, Asphalt
- Application Method
- Brush, Roller, Airless spray
- Single, Two or Three Pack
- Pack Size
- 1KG, 5KG
- Aliphatic Polyurethane
- 8-10m² per litre
- Recommended Thinner/Cleaner
- Do Not Thin
- Solids by Volume
- Touch Dry
- 2 Hours
- UN Number
Be the first to ask a question about this product!