Keim Anti-Graffiti Wax Coating
A two-coat semi-permanent anti-graffiti system made from polymers and waterbased wax, suitable for all mineral surfaces.
- Easy to apply
- Easy to remove graffiti and recoat
- High vapour permeability
This product is available as POA. Click here to email us for more information
Shipping Options (Select at Checkout):
Keim Wax Coating is a two-coat semi-permanent anti-graffiti system made from polymers and waterbased wax. Keim Wax Coating is suitable for all mineral surfaces and for surfaces which have been treated with Keim Mineral Paints.
Top Features & Benefits
- Easy to apply.
- Easy to remove graffiti and recoat.
- High vapour permeability.
- Density Q= 1.0 g/cm3.
- Processing temperature 5 - 30°C.
- Colour Transparent.
- PH 1% in water 8.5.
- Specific mass 1.00 undiluted.
- Drying time at 20°C at a relative humidity of 60%, as per:
- Dust dry: approx. 1 hour
- Non-sticky: approx. 2 hours
- Over-coat: approx. 4 hours
- Loadable: approx. 2 x 24 hours
Preparation & Application
Remove any graffiti using a high-pressure sprayer or by using Keim Graffiti Cleaner. All loose, flaking and unstable material must be identified and then thoroughly removed, all surfaces must be thoroughly washed down with clean cold water to remove all surface dirt and dust. When all surfaces are clean, sound, wind dry, dust free and free from all surface contaminants, application of Keim Wax Coating may proceed.
We would recommend that a two coat Keim Anti-Graffiti Wax Coating system be used, applied with 4 hours between coats. Each coat is applied working from the top downwards by low-pressure spray (hold the nozzle 10-20cm from the surface), apply the first coat horizontally and then the second coat vertically (cross-coats) thus ensuring that all facets of the substrate are well coated. Application using brush, roller or an airless spray gun is also possible.
To affect the removal of subsequent graffiti damage for best results remove as soon as possible after the graffiti has been applied. Graffiti can be removed using high pressure sprayer (80oC at a pressure of 60-90 BAR).
Once the graffiti has been removed and the surface is dry the Keim Anti-Graffiti Wax Coating should be reapplied.
Approx. 0.25 – 0.3 lt/m² (for two coats) Consumption rates are offered for guideline purposes only and are quoted for smooth rendered surfaces. Actual rates are the responsibility of the applicator. Project specifications should be referred to for specific rates.
Cleaning of Tools
Clean tools with water immediately after use.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- Water / Solvent Based
- For Use On
- Mineral Substrates
- Application Method
- Spray, Brush, Roller
- Single, Two or Three Pack
- Pack Size
Be the first to ask a question about this product!