Tor Torrex Fire Upgrading AG-X Finish, a decorative water based fire retardant coating for use as the finish coats of the Torrex Fire Upgrading AG-X System. Provides an outstanding non-sacrificial anti-graffiti finish that is extremely durable and easily cleaned.

For use over existing multi-layered painted surfaces to reduce the spread of flame in communal areas in the event of a fire.

Refer to the Product Data Sheet (available in the "Data Sheets" tab) for application and technical details.

Features & Benefits

• Must only be applied to surfaces which have been primed with Torrex Grip Primer EP120
• For use over existing multi-layered painted surfaces to reduce the spread of flame in the event of a fire
• Part of the Torrex Fire Upgrading AG-X System
• Two pack pigmented, polyurethane containing flame retardants
• Water-based
• Roller application
• 45% volume solids
• Very low VOC
• Quick drying - touch dry in just 2 hours, hard dry in 6 hours (at 20°C)
• 1500+ colours in RAL, RAL Design, BS, NCS and the new NCS 2050 shades
• Limitations:
  • Will only achieved fire upgrading properties if applied as part of the Torrex Fire Upgrading AG-X system
  • Torrex Fire Upgrading AG-X Finish must be applied at the specified spreading rate
  • Torrex Fire Upgrading Systems can only be applied over sound well adhered multi- layered paint surfaces. Adhesion checks must be carried out before specification of the system.
  • Do not attempt to remove graffiti until Torrex Fire Upgrading AG-X Finish has cured for at least 7 days (at 20℃).
  • Do not apply and/or allow to dry at temperatures below 5℃
  • Do not apply if condensation is likely to occur
  • Drying times will be extended if temperature falls below 10℃.

IMPORTANT FIRE PRODUCTS NOTICE: The information displayed on this website should be used as a guide ONLY and our Technical Department should be contacted to obtain a tailored specification and any advice necessary before you place an order for fire protection products. Fire protection products are non-returnable except in accordance with Condition 8 of the Terms and Conditions and should be applied only by an individual with the necessary expertise and experience. We will not be held liable for any resulting damage to property, human life or monetary costs incurred due to the incorrect specification you have prepared or use of fire protection products caused by your negligence, including your failure to have contacted us to obtain the relevant advice/specification.