Tor Aqualife TP WSE Primer, an adhesion promoter for non-porous substrates such as ceramic tiles, engineering brick and aged anti-graffiti/hard glossy coatings.

Used as a barrier coat against bitumen or graffiti, a primer for stripped surfaces, a primer/sealer for porous substrates such as plaster, concrete or render.

Refer to the Product Data Sheet (available in the "Data Sheets" tab) for application and technical details.

Features & Benefits

• For non-porous substrates such as ceramic tiles, engineering brick and aged anti-graffiti/hard glossy coatings
• A barrier coat against bitumen or graffiti
• A primer for stripped surfaces
• A primer/sealer for porous substrates such as plaster, concrete or render
• Two pack pigmented epoxy-amine
• Water-based
• Roller application
• Easy mixing; base and activator supplied in correct proportions
• 45% volume solids
• Very low VOC
• Good coverage of up to 10 square metres per litre
• Limitations:
  • Do not apply and/or allow to dry at temperatures below 5℃
  • Do not apply if condensation is likely to occur
  • Drying times will be extended if temperature falls below 10℃
  • If used externally, protect the freshly applied film from rainfall and frost
  • When used as a barrier coat the recommended spreading rate must not be exceeded or a second coat may be required to eliminate bleed

IMPORTANT FIRE PRODUCTS NOTICE:  The information displayed on this website should be used as a guide ONLY and  our Technical Department should be contacted to obtain a tailored specification and any advice necessary before you place an order for fire protection products. Fire protection products are non-returnable except in accordance with  Condition 8 of the Terms and Conditions .  We will not be held liable for any resulting damage to property, human life or monetary costs incurred due to the incorrect specification you have prepared or use of fire protection products caused by your negligence, including your failure to have contacted us to obtain the relevant advice/specification.