HMG Waterborne LMP Fluorescent is a 1K water-based acrylic based paint.
Waterborne LMP Fluorescent is part of a three coat system:
| 3 Coat System Details | |||||
|---|---|---|---|---|---|
| Coat 1 | HMG Waterborne LMP Colours (matt white) | ||||
| Coat 2 | HMG Waterborne LMP Fluorescent | ||||
| Coat 3 | Overcoat with HMG Hydrothane 2018 (Clear) to attain gloss, improve durability and help protect against UV degradation | ||||
HMG Waterborne LMP Fluorescent is a 1K water-based acrylic based paint..
Waterborne LMP Fluorescent is part of a three coat system:
| 3 Coat System Details | |||||
|---|---|---|---|---|---|
| Coat 1 | HMG Waterborne LMP Colours (matt white) | ||||
| Coat 2 | HMG Waterborne LMP Fluorescent | ||||
| Coat 3 | Overcoat with HMG Hydrothane 2018 (Clear) to attain gloss, improve durability and help protect against UV degradation | ||||
Please note more than one coat of each may be required depending on application to achieve desired results.
| Technical Data | ||||||
|---|---|---|---|---|---|---|
| HMG Waterborne LMP Fluorescent | ||||||
| Volume Solids: | 57.9% | |||||
| VOC Content: | 0.11kgs/ltr | |||||
| SG: | - | |||||
| Viscosity: | 2500 mPas | |||||
| Density: | 1.127 g/cm³ | |||||
| Storage Conditions: | Store between 5°C - 25°C. When not in use, cans must be kept sealed. | |||||
| Shelf Life: | 12 months from delivery date in original sealed containers. | |||||
| Pot Life: | - | |||||
| Flash Point: | n/a | |||||
Additionl Technical Information:
| Product Data | |||
|---|---|---|---|
| Dry Film Thickness | Wet Film Thickness | ||
| Compliant Spray Gun: | 30 μm | 80 μm | |
Coverage: 12 square metres per litre @ 30 microns dft (theoretical)
| Drying Times At 20°C | |
|---|---|
| Touch Dry: | 30 minutes |
| Dry To Recoat: | 16 hours minimum - 14 days maximum |
| Fully Cured: | 24 hours |
| Technical Data | |||||
|---|---|---|---|---|---|
| Application | |||||
| Mixing Ratio: | Base: 5ltr | ||||
| Thinner: >10% | |||||
| Thinner Options: | Water | ||||
| Viscosity: | As supplied | ||||
| Spray Gun Setup: | - | ||||
| Number Of Coats (Guide Only): | 1 - 2 coats | ||||
| Flash Off: | - | ||||
For further information on mixing ratios please contact Rawlins Paints on Tech - 0113 2455450 (option 2) or [email protected] Sales - 0113 2455450 or [email protected]
| Information On Basic Physical And Chemical Properties | ||||||
|---|---|---|---|---|---|---|
| HMG Waterborne LMP Fluorescent | ||||||
| Form: | According to product specification | |||||
| Colour: | According to product specification | |||||
| Odour: | Characteristic | |||||
| Odour Threshold: | Not determined | |||||
| pH-value 20°C: | Not determined | |||||
| Melting point/freezing point: | Undetermined | |||||
| Initial boiling point and boiling range: | 100°C | |||||
| Flash Point: | n/a | |||||
| Flammability (solid, gas): | Not applicable | |||||
| Ignition temperature: | 371°C | |||||
| Decomposition temperature: | Not determined. | |||||
| Auto-ignition temperature: | Product is not selfigniting. | |||||
| Explosive properties: | "Product is not explosive. However, formation of explosive air vapour mixtures are possible." | |||||
| Explosion limits: Lower: | Not determined | |||||
| Explosion limits: Upper: | Not determined | |||||
| Vapour pressure at 20°C: | 23 hPa | |||||
| Density at 20°C: | 1.127 g/cm³ | |||||
| Relative density: | Not determined | |||||
| Vapour density: | Not determined | |||||
| Evaporation rate: | Not determined | |||||
| Solubility in / Miscibility with water: | Fully miscible | |||||
| Partition coefficient: n-octanol/water: | Not determined | |||||
| Viscosity: Dynamic at 20°C: | 2500 mPas | |||||
| Viscosity: Kinematic: | Not determined. | |||||
| Solvent content: Organic solvents: | 9.6% - Water 38.7% | |||||
| Solids content: | 57.9% | |||||
Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.
HMG Waterborne LMP Fluorescent is only available with the shipping and delivery timescales listed below - please do not contact our Customer Support Team with enquiries about alternative or earlier shipping and delivery times.
Saturdays and Sundays, as well as Bank Holidays, are not classed as working days.
Orders placed after the cut-off for this product will not be processed for earliest dispatch until 9am the next working day.
All delivery costs below are excluding VAT
HMG Waterborne LMP Colours is a high quality 1K water-based acrylic based paint range offering excellent drying characteristics.Excellent adhesion to a wide variety of substrates and ease of brushability. Developed as an alternative to solvent based alkyd synthetic enamels for situations where its particular properties are preferred....
£38.75 (incl. VAT)
£32.29 (ex. VAT)
HMG Thinner 2612 is a slow thinner.For use with compatible HMG systems.More Information Delivery Info
£13.99 (incl. VAT)
£11.66 (ex. VAT)
