Jotun Tankguard Storage
A two component novolac epoxy coating is a specially designed tank lining with excellent chemical resistance. It can be used as primer, mid coat and finish coat in atmospheric and immersed environments.
Jotun Tankguard Storage is a two component polyamine cured novolac epoxy coating that is a specially designed tank lining with excellent chemical resistance. It can be used as a primer, mid coat or finish coat in atmospheric and immersed environments. Suitable for properly prepared carbon steel, galvanised steel, stainless steel and concrete substrates.
Jotun Tankguard Storage is specially designed as an internal lining for offshore, onshore and buried tanks and pipes such as chemical storage, waste water, grey water, process water, concrete bund, fire service lines and drilling mud tanks. Can be used in pressure vessels. This coating has very good resistance to high temperature products. Refer to Protective Product Resistance List.
Approvals and certificates
- Approved to UK Defence Standard 80-97 isue 5, annex G for resistance to Avcat F-44 aviation fuel
Additional certificates and approvals may be available on request.
Features & Benefits
- Chemical resistant
- Resistant against crude oil up to 90°C
- Application of two coats in one day
- Flexible dry film thickness range 125 - 200 μm
High solids tank coating with high temperature resistance
Tankguard Storage provides corrosion protection for the internal lining of steel storage tanks. It is resistant to a wide range of chemicals including, but not limited to, crude oil and aromatic and aliphatic solvents and others.
Certificates and approvals
- Approvals for Aviation Fuel and food contact
- Approved for PSPC COT
When there is a need for a temporary protection of the blasted steel Tankguard Storage can be used in a system with Tankguard Holding Primer as the first coat.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
|The figures stated above are approximate. Please ensure you refer to all datasheets for full application information.|
Be the first to ask a question about this product!
Colour reproduction of the Products on the Site is limited by the technology used to deliver web pages and by the colour representation of Customer’s own monitor and computer set-up. We have made every effort to display as accurately as possible the colours of our Products but we cannot guarantee that the colour shown on Customer’s monitor’s display will accurately reflect the colour of the Product on delivery. We recommend that Customer first purchases the smallest Product available or access an industry standard colour chart in person (and not digitally) to ensure that the colour is acceptable for its purposes. For more information, please see our Terms & Conditions of Sale.Close