Solignum Architectural (Solvent Based)
Architectural™ (solvent based) is a decorative microporous, flexible coating which allows all kinds of timber to breathe.
Architectural™ (solvent based) is a decorative microporous, flexible coating which allows all kinds of timber to breathe. The low sheen opaque finish provides excellent water shedding properties. Architectural™ resists mould growth and protects timber from UV light. The wood stain penetrates the surface of the timber giving perfect adhesion, so no separate primer is required and the surface will not flake or crack.
• Opaque finish
• BBA tested performance
• Life expectancy in excess of 5 years
• Water repellant
• Suitable for use with pre-treated and pre-stained timbers
• Suitable for all year round use
• Touch dry in 4 hours
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- Brush, Spray
- 4-12m² per litre
- Touch Dry
- 4-6 Hours
|John Davis on 2019-09-09 19:32:41|| |
Can Solignum architectural solvent based be applied over external joinery previously painted with the Solignum water based product
You can overpaint the water based with the solvent when it has weathered but it may be just as easy in this instance to re-apply the water based version if this is what was used before.
|John Davis on 2019-09-09 19:29:20|| |
If cost is not the primary consideration what is better, in terms of protection and durability, for external windows and doors in an exposed position, Solignum architectural water based or spirit based?
There is not much difference in performance between the 2 products. You can expect a redecoration interval of 5 years plus for both.
|tony jones on 2019-05-24 16:07:46|| |
Can solignum architectural opaque woodsstain be used on previously treated surfaces or does the surface have to betaken back to original wood surface
The data sheet states 'Wood should be unweathered, bare, dry, free of mould, dirt, bark, paint, varnish or polish.'
If your timber is previously coated with something, you may be better looking at the Zinsser AllCoat Exterior range.
|brenda smith on 2016-09-13 08:22:41|| |
Question: How many coats would we need for a new pretreated five bar gate It has to be white as that is the name of our house !
2-3 coats by brush should be applied directly to the prepared timber. You can find full application instructions in the Technical Data Sheet available for download form the 'DATASHEETS' tab just above the main description on the product page.
|John azzopardi on 2016-05-10 11:08:27|| |
Question: How far does a 5 ltrs go??? Thanks john.
Sawn Timber: 20-40m² per 5L / per coat