This product is temporarily unavailable; in the meantime, our technical team recommend Thermoguard Thermostrip PRO as a great alternative. Please note: it is important to check that any alternative product is suitable for your requirements, as our suggestion is given in good faith but without warranty. If you are in any doubt please first...
Blackfriar UV Wood Primer
This product is temporarily unavailable; in the meantime, our technical team recommend KoverTek G-40 Multiseal as a great alternative.
Please note: it is important to check that any alternative product is suitable for your requirements, as our suggestion is given in good faith but without warranty. If you are in any doubt please first contact our technical team on 0113 2455450 (option 2) or send a message to [email protected] where we will be happy to discuss your project.
Blackfriar UV Wood Primer is designed to bind with wood grain to provide superior protection against UV damage, the main cause of varnish failure. Enriches and protects your exterior home and garden wood.
- Enriches and protects your home and garden wood.
- Binds with the wood grain.
- For use under Blackfriar Exterior Varnishes.
- Protects from UV damage.
- Significantly extends varnish durability.
- For use on bare or stripped wood.
Blackfriar UV Wood Primer is designed to bind the wood grain to provide superior protection against UV damage, which is the main cause of varnish failure. Enriches and protects your exterior home and garden wood.
New timber and joinery should be clean, dry and smooth. Any knots should be cleaned off with methylated spirit. Rub it down with fine glasspaper, following the grain and removing any dust. Remove oil, grease, dirt or surplus glue to prevent these showing through the primer. Oily woods, such as teak or iroko, should be thoroughly cleaned with a cloth impregnated with white spirit to remove natural oils. Non-ferrous nails are recommended for fixing beading etc. Remove old varnish completely with Blackfriar Professional Paint and Varnish Remover and then treat as new timber. Any French Polishes must also be completely removed.
Apply 2 coats of Blackfriar UV Wood Primer by brush. Followed by 2 coats of Blackfriar Exterior Varnish for maximum durability. Work Blackfriar UV Wood Primer into all areas of detail and joints. Allow to dry fully between coats. Do not apply to very damp wood as this will limit penetration and affect durability.
Touch dry in 30 mins. Overcoat after 2- 3hrs at 10°C.
Remove as much product as possible from application equipment before washing with water. Do not empty product into drains or watercourses. Some local authorities have special facilities for the disposal of waste coatings.
Features & Benefits
- Binds wood grain
- For use under Blackfriar Exterior Varnishes
- Protects from UV damage
- Significantly extends varnish durability
- For use on bare or stripped wood
Please contact Rawlins Paints' Technical Support Team on 0113 2455450 for more information.
- Blackfriar Professional
- Interior / Exterior Use
- Water / Solvent Based
- For Use On
- Unprepared, Prepared
- Application Method
- VOC Levels
- Ultra-Low (5-49 g/l)
- Single, Two or Three Pack
- Pack Size
- 12-14m² per litre
- Recommended Thinner/Cleaner
- Touch Dry
- 30 Mins
- UN Number
- Dry to Recoat (at 10°C)
- Exterior / Interior Use
- Exterior Use
- Type of Wood Finish
- Wood Primers
Be the first to ask a question about this product!
General Painting Application Kit from Rawlins Paints provides the basics for any painting project. Whether it is a one off job, or you just want to make sure the right application tools get to site. Provides an economical way of making sure you will have what you need Ideal for interior and exterior paint projects Click to jump down to...