• Blackfriar Raw Linseed Oil

Blackfriar Raw Linseed Oil


Blackfriar Raw Linseed Oil penetrates deep into wood, nourishing it from within. It is ideal for oak beams, cricket bats and bean canes.

  • Nourishes and protects all wood
  • Penetrates deep into wood
  • Suitable for most woods
  • Interior and exterior use
  • Can also be used for softening glazing putty
  • Applies by brush or rag
  • Good coverage of up to 10m² per litre
  • Can be used as a lubricant for French Polish
  • Can be recoated after 12 hours
  • Solvent Based
  • Click to jump down to Technical Data

VAT excluded

£7.24 Tax incl.


Blackfriar Raw Linseed Oil penetrates deep into wood, nourishing it from within. Ideal for oak beams, cricket bats and bean canes, it can also be used for softening glazing putty and as a lubricant for French Polish. It can be used both internally and externally, applied liberally by brush or a rag. Blackfriar Raw Linseed Oil is non-drying as it absorbs deeply into wood and can be recoated after 12 hours.

Quick Links - Click To Jump To Section:

Features & Benefits

  • Interior and exterior use
  • Nourishes and protects wood
  • Penetrates deep into wood
  • Suitable for most woods
  • Ideal for oak beams, cricket bats and bean canes
  • Can be recoated after 12 hours
  • Good coverage - up to 10m² per litre


Ensure surface to be oiled is smooth, clean, dry and free from any surface contamination. For surfaces previously treated with oils or waxes clean back the surface to bare timber with fine wire wool and white spirit, working along the grain.


Ensure the product is thoroughly shaken prior to use. Apply oil liberally by brush or rag. Leave for a few minutes for the oil to absorb into the wood then wipe off any surplus. Allow the oil to dry overnight before using or recoating. When applying to new wood thin the first coat with 10% white spirit.


Maximum 10% white spirit.


If used on exterior projects, very regular maintenance will be required to keep the wood nourished.


Up to 10m2 per litre per coat.

Drying Time

  • Non-drying.
  • The product is absorbed into the wood.
  • Recoat after 12 hours.

Clean Up

Take extra care as application cloths and soiled cleaning rags may self ignite without warning. Lay cloths out flat in single layers to dry, or wash out thoroughly in warm soapy water before disposal.

Remove as much product from application equipment as possible before washing with white spirit. Do not empty into drains or water courses. Some local authorities have special facilities for the disposal of waste coatings.


Store in a dry, safe place. Do not store in environments where extreme temperatures may occur. Keep within 5-30°C. Do not store in direct sunlight.

Health And Safety

    • Keep out of reach of children.
    • Read label before use.
    • If medical advice is needed, have product container or label at hand.
    • Dispose of contents and container in accordance with all local, regional, national and international regulations.
    • EU limit values: 500g/l (2007) 400g/l (2010.) This product contains a maximum of 100g/l VOC.


Please contact Rawlins Paints' Technical Support Team on 0113 2455450 (option 2) or send a message to [email protected] for more information.

Click to go back to the top of the page

It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.

Product Details

Data sheet

Blackfriar Professional
Interior / Exterior Use
Interior and Exterior
Water / Solvent Based
For Use On
Application Method
Brush, Cloth
Standard / Ready Mixed
VOC Levels
Low (50-149 g/l)
Single, Two or Three Pack
Pack Size
10m² per litre
Recommended Thinner/Cleaner
White Spirit
Touch Dry
Does not dry

Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.

Be the first to ask a question about this product!

Question about the product

* Required fields