Teamac Teak Oil
  • Teamac Teak Oil

Teamac Teak Oil

538/V601/28

Teamac Teak Oil, is a blend of natural oils and silicone derivatives which enhance, preserve and restore the appearance of teak and other hardwoods.

Advantages

Colour
Size
£18.36
VAT excluded

£22.03 Tax incl.
Quantity

Description

Teamac Teak Oil, is a blend of natural oils and silicone derivatives which enhance, preserve and restore the appearance of teak and other hardwoods.



Click To Jump To Section:




Features & Benefits


Advantages



Product Specification


Technical Data
Volume Solids 34%
VOC Content Max 514 g/litre
SG 0.86 @ 20 °C
Viscostity Thin Liquid
Flash Point Above 32°C (closed cup)



Film Thickness Range And Coverage


Product Data
  Dry Film Thickness Wet Film Thickness Theoretical Coverage
Maximum N/A N/A 7 m2/litre



Average figure dependant on the porosity of the wood.

The practical spreading rate may be lower as this depends on factors such as the porosity and roughness of the surface to be painted and material losses during application.



Drying Times


Drying Times At 20°C/RH 50%
Touch Dry: 8 Hours
Dry To Handle: 24 Hours
Dry To Recoat: 16 hours or overnight
Fully Cured: N/A



Low temperature and high humidity will adversely affect application, drying and performance of any coating.



Surface Preparation


  • All surfaces should be clean, dry, sound and free from contaminants. 
  • Ensure the surface is left to dry for 1 to 2 weeks.
  • Use sandpaper to remove any unwanted old coatings or paints.



Preceeding Coat


  • Apply direct to wood.



Mixing


  • Mix well before use.



Application Conditions


  • As dictated by normal good painting practice. In confined spaces, provide adequate ventilation during application and drying.
  • Apply as a flood coat, work well into the grain, taking particular care at "end" grains.



Application Methods


Method Airless Spray Conventional Spray Brush Roller
  No No Yes No



  • Thinner (Max vol): N/A
  • Nozzle Size: N/A
  • Nozzle Pressure: N/A
  • Cleaning Solvent: Thinners 14



Health & Safety


See safety data sheet - SDS 11372 in the attachments section above.

Click to go back to the top of the page

It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.

Product Details
538/V601/28

Data sheet

Manufacturer
Teamac
Application
Brush
Touch Dry (at 20°C)
8 Hours
Dry to Handle (at 20°C)
24 Hours
Dry to Recoat (at 20°C)
16 hours or overnight
Fully Cured (at 20°C)
N/A
Coverage
7 m²/litre
Recommended Thinner/Cleaner
Thinners 14
Solids by Volume
34%
VOC
Max 514 g/litre
Finish
Oiled
Size
0.5 litre, 1 litre, 2.5 litre
Recommended Dry Film Thickness
N/A
Recommended Wet Film Thickness
N/A
Attachments
Download


Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.


questions peter on 17/09/2019
Question: 

Hi, I have floating oak shelves which I want to use outdoors on my patio. Can i use a teak oil to protect the wood from the elements or if not what product would you recommend? Thanks in advance, Peter

Answer: 

Yes, Teamac Teak Oil would be ideal for this application.


Question about the product

* Required fields
(read)
Send
You might also like

Teamac Thinner 14

A specially formulated blend of solvents designed to mix with its compatible Teamac or Coo-Var coating to create an optimal consistancy for application. Suitable for use with Brush, Roller or Spray. Teamac Thinner 14 can also be used for the cleaning of some surfaces prior to application of the coating. Also suitable for the cleaning of...

Price £11.72
In stock
16 other products in the same category:

Rust-Oleum 4900 Polycoat 2K

Rust-Oleum 4900 Polycoat 2K is a clear, water-based, 2-component polyurethane topcoat for use on wood, concrete and pre-painted surfaces, also serves as an anti-graffiti coating. Very abrasion resistant, available in a matt or gloss finish, does not yellow, can be used internally and externally, resists boiling water, alcohol, coffee, red...

Price £25.52
In stock

Instarmac UltraCrete QC10 Rapid Strength Concrete

Designed for thick section repairs, haunching reinstatements, ironwork backfilling and commerical sign/post installation. HAPAS Approved since 2005 20N/mm² compressive Rapid set: 10-20 minutes strength in 2 hours Open to traffic: 2 hours • Shrinkage compensated

Price £20.15
In stock

Coo-Var Polyurethane Varnish

Coo-Var Polyurethane varnish is a single pack product of exceptional durability based on urethane alkyd. For interior use only. Product Features For Interior Use Suitable Surfaces: Wood Finish: Matt Application: Roller or brush Drying time: Touch Dry 2 hours or 12 hours hard dry Overcoat time: 12 hours or overnight Estimated...

Price £16.42
In stock

Blackfriar Raw Linseed Oil

Blackfriar Raw Linseed Oil penetrates deep into wood, nourishing it from within. It is ideal for oak beams, cricket bats and bean canes. Nourishes and protects all wood Penetrates deep into wood Suitable for most woods Interior and exterior use Can also be used for softening glazing putty Applies by brush or rag Good coverage of up to...

Price £5.75
In stock

Teamac Danish Oil

Teamac Danish Oil, is hard, durable, water resistant seal for the enhancement of interior and exterior wood containing tung oil. Advantages Can be used for kitchen worktops, wooden panels, garden furniture and doors. Ideal to provide a more natural appearance on timber. Click to jump down to Technical Data

Price £18.98
In stock

Mathys Fassilux Aqua XPE Satin

Mathys Fassilux Aqua XPE Satin is a water based, satin finish for interior and exterior timber and previously painted mineral substrates to provide a smooth, scratch resistant finish. Can be used in- and exterior Quick drying Low in odour and VOC, Easy to apply Excellent flow and levelling characteristics Superior scratch resistance...

Price £19.57
In stock

Thermilate InsOpaint Gloss

Thermilate InsOpaint Gloss is an innovative, eco-friendly, water based gloss paint with a non-yellowing finish, ideal for interior wood and metal. This specially formulated, water based gloss gives all the appearance and characteristics of traditional gloss but has advanced durability, high opacity and fast drying times.

Price £59.95
In stock

Coo-Var Eggshell

Coo-Var Eggshell is an interior and exterior oil-based finish for primed wood, metal and masonry that dries to a white eggshell finish. Product Features Interior/Exterior use Decorative Eggshell/Satin finish Suitable for wood, metal or masonry Off-white finish Great for Tudor brickwork and beams

Price £12.33
In stock

Timberex Wax-Oil

Timberex Wax-Oil greatly enhances colours and grain and allows wood to age naturally into rich varying tones. Made from fast curing natural oils and carnuba wax it cures to a deep satin finish.

Price £20.03
In stock

Bedec Frosting Varnish

Use on glass or clear plastic to give the effect of etched or obscure glass. Can be tinted to look like old stained glass windows. Also gives some heat loss resistance.

Price £20.19
In stock

Timberex Coloured

For commercial or domestic use, on floors, stairs, panelling etc. Timberex Coloured penetrates deeply into the wood filling the pores to form a wear and water resistant surface.

Price £18.47
In stock

Timberex Aqua Plus

Timberex Aqua Plus is a water-based polymer wood coating for fast and easy industrial protection. Very rapid curing saves time and costs. Stains and protects at the same time.

Price £26.15
In stock

Mathys Fassilux Aqua XPE Matt

Mathys Fassilux Aqua XPE Matt is a water based, scratch resistant matt finish for interior timber and previously painted mineral surfaces. Specially designed for interior use Quick drying Low in odour and VOC Easy to apply Excellent flow and levelling characteristics Superior scratch resistance Stable gloss Good adherence Hiding...

Price £19.57
In stock

Timberex Enviro

A low-VOC wood oil for protection against stains and wear. Very rapid curing saves time and costs. Non-yellowing, non-darkening and easy to maintain and clean. Can be used as a Topcoat for Timberex Aqua and Active Stain.

Price £23.00
In stock

Blackfriar Matt Black Paint

Blackfriar Matt Black Paint is a matt black non-reflective paint which is ideal for interior metal, wood and plaster. Recommended for timber beams, iron work, stage scenery and darkrooms. A practical and versatile product. Product Features Matt black. Non-reflective. Interior use. For wood, metal and plaster.

Price £14.08
In stock

Coo-Var Matt Black (Solvent Based)

Coo-Var Matt Black gives a quick drying nonreflective finish to wood, metal, ironwork, plaster and many more surfaces. Product Features For tudor style beams. Photographic work. Chalk boards. Anywhere a non-reflective surface is required. Not suitable for canvas roller chalk boards. Suitable for interior and exterior use.

Price £13.89
In stock