Sikagard Wood Preserver
Sikagard Wood Preserver is a low solvent, low odour solution based on Micro-fine active technology. The fungicides and algaecides present in these formulations are finely dispersed so that wood penetration and hence effectiveness is much greater than standard wood preservation products. Ultra light fast pigments give an even fade resistant finish which will last for years.
Sikagard Wood Preserver is a low solvent, low odour solution based on Micro-fine active technology. The fungicides and algaecides present in these formulations are finely dispersed so that wood penetration and hence effectiveness is much greater than standard wood preservation products. In addition the use of ultra light fast pigments on the coloured variants give an even fade resistant finish which will last for years. Sikagard Wood Preserver is fast drying and non flammable; and application to wet timbers is possible without loss of performance. It is specifically designed to deeply penetrate all wood and joinery to give long lasting protection from damage caused by wet rot, dry rot, decay and fungi.
Features & Benefits
- Solvent Free formula
- Non Flammable
- Internal and external use
- Can be applied to damp timbers
Areas for Use
For use on interior or exterior rough sawn or planed timber such as floorboards, joists, roof timbers, window frames and doors. This product is an ideal pre-treatment which may be over painted, varnished, or stained when dry (allow 48 hours drying time), but on interior applications, it may also be left as the final finish for a natural wood effect. However, when used externally, over painting/staining is recommended, as this product does not repel water.
For more details please download the product data sheet from the 'DATASHEETS' tab above.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
|The figures stated above are approximate. Please ensure you refer to all datasheets for full application information.|
Be the first to ask a question about this product!
Colour reproduction of the Products on the Site is limited by the technology used to deliver web pages and by the colour representation of Customer’s own monitor and computer set-up. We have made every effort to display as accurately as possible the colours of our Products but we cannot guarantee that the colour shown on Customer’s monitor’s display will accurately reflect the colour of the Product on delivery. We recommend that Customer first purchases the smallest Product available or access an industry standard colour chart in person (and not digitally) to ensure that the colour is acceptable for its purposes. For more information, please see our Terms & Conditions of Sale.Close