Blackfriar Red Oxide Metal Primer is an anti-corrosive, red oxide primer for the protection of ferrous metals. Specifically formulated for painting ferrous surfaces such as iron and steel to prevent rust forming. Contains zinc phosphate. Product Features Anti-corrosive. Prevents rust. For ferrous metals such as iron and steel. Interior...
Blackfriar MDF Primer Undercoat
Blackfriar MDF Primer Undercoat is an excellent quick drying all-in-one primer/undercoat specially formulated for MDF. May also be used as a primer/undercoat over interior masonry, dry plaster and cement.
- Fast drying.
- All-in-one primer and undercoat.
- Good opacity.
- Excellent adhesion to MDF.
- Interior use.
Blackfriar MDF Primer Undercoat is especially designed for use on MDF. It’s easy to use and dries quickly so you can prime, undercoat and finish all in one day. It can be overcoated with a choice of finishes including gloss, emulsion and satins.
An excellent quick drying all-in-one primer/undercoat specially formulated for MDF. May also be used as a primer/undercoat over interior masonry, dry plaster and cement.
Ensure surface to be coated is clean, dry, sound and free from wax, grease or any other contamination. Exposed ferrous metal (eg. nails) should be spot primed with the appropriate Blackfriar metal primer.
Stir thoroughly prior to use with a broad stirrer. The product may be applied by brush, roller or spray. Two coats are recommended to give best protection. For porous surfaces or if applying by spray the product may be thinned up to 10% with water.
Maximum 10% water.
Touch dry in 1 - 2 hours. Recoat after 4 hours. Drying times are based on an ambient temperature of 20°C and 50% relative humidity. Lower temperatures or higher humidity will prolong the drying and overcoating times.
Remove as much product as possible from application equipment before washing with water. Do not empty into drains or water courses. Some local authorities have special facilities for the disposal of waste coatings.
Store in a dry, safe place. Do not store in environments where extreme temperatures may occur. Keep within 5-30°C. Do not store in direct sunlight.
Features & Benefits
- All-in-one primer & undercoat for MDF
- Perfect for pre-decoration
- White finish
Please contact Rawlins Paints' Technical Support Team on 0113 2455450 for more information
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- Blackfriar Professional
- Interior / Exterior Use
- Water / Solvent Based
- For Use On
- Application Method
- Brush, Roller, Spray
- Standard / Ready Mixed
- VOC Levels
- Ultra-Low (5-49 g/l)
- Single, Two or Three Pack
- Pack Size
- 1L, 2.5L, 5L
- 14m² per litre
- Recommended Thinner/Cleaner
- Touch Dry
- 1-2 Hours
|maxine lane on 2015-10-14 13:47:34|| |
Can Blackfriar MDF Primer Undercoat be used on bare wood also?
Yes, it may also be used as a primer undercoat over wood, masonry, dry plaster, cement and more.
Blackfriar Multi-Surface Primer has been specially formulated to prime multiple surfaces prior to further painting. It’s ideal for hard and soft woods, chipboard, plywood, GRP, MDF, exterior UPVC, ceramic tiles, iron, steel, galvanised and non-ferrous metals (aluminium, brass, chrome, copper) and old plaster. Product Features Interior and...