Blackfriar Patent Knotting solution seals and prevents seepage from knots and resinous areas on timber. For use on interior and exterior bare or stripped wood. Product Features Interior and exterior use. Seals knots. Prevents seepage. Translucent amber solution. Use only under opaque coatings.
Blackfriar Aluminium Wood Primer
Blackfriar Aluminium Wood Primer is an aluminium wood primer for hardwoods, which prevents bleed through fresh paintwork. Specifically formulated for painting new or old bare hard or resinous woods.
- Contains aluminium pigments to protect against bleed from resinous woods.
- For resinous and bare hard woods.
- Good barrier properties.
- Interior and exterior use.
Blackfriar Aluminium Wood Primer is for hardwoods, to prevent bleed through to fresh paintwork. Specifically formulated for painting new or old bare hard or resinous woods.
Ensure surface to be coated is clean, dry, sound and free from wax, grease or any other contamination. Treat knots and resinous areas with Blackfriar Patent Knotting and allow to dry before applying Blackfriar Aluminium Wood Primer.
Stir thoroughly prior to use with a broad stirrer. The product may be applied by brush, short pile roller or spray. Apply a generous even coat and brush well into the grain. Apply one or two coats as required.
Maximum 5% white spirit.
Do not use under cold (less than 5°C), damp or humid conditions. Oily hardwoods such as Teak or Iroko must be fully degreased with white spirit or methylated spirits prior to application of this product. Failure to do this may result in extended drying times and/or adhesion failure.
Remove as much product as possible from application equipment before washing with white spirit. Do not empty into drains or water courses. Some local authorities have special facilities for the disposal of waste coatings.
Store in a dry, safe place. Do not store in environments where extreme temperatures may occur. Keep within 5-30°C. Do not store in direct sunlight.
Features & Benefits
- For resinous and bare hard woods
- Good barrier properties
- Interior and exterior use
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- Blackfriar Professional
- Interior / Exterior Use
- Interior and Exterior
- Water / Solvent Based
- For Use On
- Hardwood, Unprepared
- Application Method
- Brush, Roller, Spray
- Standard / Ready Mixed
- Single, Two or Three Pack
- Pack Size
- 1L, 2.5L
- 14m² per litre
- Recommended Thinner/Cleaner
- White Spirit
- Touch Dry
- 2-4 Hours
|mary on 2019-04-15 12:25:24|| |
how long is the drying time please?
Touch dry in 2 - 4 hours. Recoat after 16 hours and within 3 days. Drying times are based on an ambient temperature of 20°C and 50% relative humidity. Lower temperatures or higher humidity will prolong the drying and overcoating times.
|Robert on 2016-08-01 17:53:51|| |
Question: Hi Is this product suitable for marine applications, specifically the hulls of wooden boats? Thanks
Blackfriar Aluminium Wood Primer is not suitable for this applicaton but Teamac Aluminium Wood Primer is. Our normal specification for new, bare timber would be;