- There are no more items in your cart
- Shipping Calculated at checkout
-
Sub-Total (inc. VAT)
£0.00
Keim Concretal-FSP 0.2 (Fine Finishing Mortar) - Fine filler for the KEIM Concretal concrete repair system.
- Supplied in 25kg Bag
- Up to 12-months shelf life
- Apply using trowel or spray
- One-component – Low-shrink – Crack-free haredening
- Frost-resistant and salt-resistant
- Resistant to aging – Synthetic-modified
Note: The name of this product will change in early 2023 - also known as Keim Concretal Fine Finishing Mortar
Keim Concretal-FSP 0.2 (Fine Finishing Mortar) - Fine filler for the KEIM Concretal concrete repair system.
Top Features & Benefits
- Supplied in 25kg Bag
- Up to 12-months shelf life
- Apply using trowel
- One-component – Low-shrink – Crack-free haredening
- Frost-resistant and salt-resistant
- Resistant to aging – Synthetic-modified
Preparation & Application
Substrate Preparation
- The substrate must be clean, sound, open-pored and absorbent.
- It must be dust-free and load-bearing.
- Roughen dense, smooth substrates.
- Remove dirt, cement slurries and non-load-bearing layers by blasting (for explanations, see ZTV-ING Part 3 Section 4 Tab. 3.4.2, Preparation of the concrete substrate).
- The surface tensile strength of the substrate must comply with the relevant technical regulations ZTV-ING or Rili-SIB.
- Depending on the absorption behaviour, the substrate must be prewetted from approx. 2 hours prior to application
- The substrate should be matt damp but not saturated with water, avoid standing water
Application Notes
- Apply the mixed KEIM Fine-Finishing-Mortar with a trowel in layer thicknesses from approx. 0.5 mm to max. 4 mm
- In case of full filling, apply max. layer thickness per working cycle 2 mm
- For larger pores and cavities, apply a scratch coat (with a hard rubber trowel)
- KEIM Fine-Finishing-Mortar can also be used without surface application as a scratch filler to close pores and cavities
- Screw pumps with variable delivery rates are particularly suitable for wet spraying
- When used as a blowhole slurry, the addition of Keim Concretal-Fine Filler Dilution to the mixing water is required
Please see the Technical Data Sheet for detailed application instructions.
Application Conditions
Ambient and substrate temperature above 5°C and below 30°C. Do not apply in direct sunlight or onto sun-heated surfaces, nor if it is raining or if there is an immediate likelihood of rain.
Consumption
Approx. 2,0 kg/m² per mm for full-cover skim coating approx. 0,8 - 1,5 kg/m² for scratch filling (depending on the pore volume)
Data sheet
- Single, Two or Three Pack
- Single
- Suitable For Use On
- Concrete
- Application Method
- Trowel
- Product Usage Type
- Mortar
- Product Range
- Concretal
Be the first to ask a question about this product!
IMPORTANT SHIPPING & DELIVERY INFORMATION
Keim Concretal-FSP 0.2 (Fine Finishing Mortar) is only available with the shipping and delivery timescales listed below - please do not contact our Customer Support Team with enquiries about alternative or earlier shipping and delivery times.
Saturdays and Sundays, as well as Bank Holidays, are not classed as working days.
Orders placed after the cut-off for this product will not be processed for earliest dispatch until 9am the next working day.
All delivery costs below are excluding VAT