Tenmat FF109 Downlighter Covers are fire and acoustic rated light covers or fire hoods designed to fire rate downlight fixtures and reinstate the performance of ceilings when penetrated by recessed downlights. The covers are available in various sizes to suit a wide range of lighting products over and above those covered by fire rated downlights.

The covers are simple to install and can be retrofitted into position, providing effective performance even if the downlight is removed and replaced. They prevent combustible materials from coming into contact with hot downlighters – thus minimising fire risk. The covers are ventilated to allow heat to disperse from the light, but in the event of a fire the intumescent material expands to seal off the ceiling cut-out and vent holes.

Quick Links - Click To Jump To Section:

• Features & Benefits
• Test Data
• Product Dimensions
• General Fitting Instructions

Features & Benefits

• Flexible and lightweight
• Up to 120 minutes fire rating
• Cost effective
• Ventilated to reduce heat build up
• Provides thermal and acoustic insulation
• Can be fitted from above or below the ceiling

Test Data

* 150x150mm & 200x200mm only

Product Dimensions

General Fitting Instructions

For detailed fitting instructions for various applications please contact our technical team on 0113 2455450 (option 2) or send a message to [email protected]

• Grasp legs firmly and roll cover into a tight cylinder. Ensure wiring loom is through slot before installation
• Keeping a tight grip on the legs, feed the cover through the cut out made for the downlighter
• Ensure cover has sprung back into its original cone shape

• Grasp legs and pull down until L section clears the underside of the ceiling
• Move legs out until vertical part of L section is flush with the side of the cut out
• Release the legs so they grip the underside of the tile
• Remove the excess of both legs

• Once cover is in place, downlighter can be fitted as normal, with transformer outside the cover

• If required, an intumescent sealant can be used to ensure a smoke and acoustic seal

IMPORTANT FIRE PRODUCTS NOTICE: The information displayed on this website should be used as a guide ONLY and our Technical Department should be contacted to obtain a tailored specification and any advice necessary before you place an order for fire protection products. Fire protection products are non-returnable except in accordance with Condition 8 of the Terms and Conditions and should be applied only by an individual with the necessary expertise and experience. We will not be held liable for any resulting damage to property, human life or monetary costs incurred due to the incorrect specification you have prepared or use of fire protection products caused by your negligence, including your failure to have contacted us to obtain the relevant advice/specification.