These surface preparation kits for steel have been created to help provide customers with an easily accessible bundle of tools to aid in the preparation of steel surfaces in accordance with ISO 8501-1 (St2/3) and SSPC (SP 2/3). Please click here for important information about these kits. Kit Contents: SET 1 (Hand Tools) 1 x Rust-Oleum...
Sherwin-Williams Kem-Kromik 155
Kem-Kromik M155 (formerly known as Sherwin-Williams M155 or Leighs M155) is a quick drying alkyd anticorrosive protective finish pigmented with zinc phosphate, used for protection of steel where speed of drying is important. Can be applied by airless spray or roller, using a brush only for small areas or touching up.
- Please note: This product is also available on a made to order basis in Red Oxide and Light Grey* in a 5L pack size, and Blue* in 20L pack size subject to an extended lead time (*Minimum order quantity of 200L applies)
- Please contact us on 0113 2455450 (option 1) or send a message to [email protected] for further information
Kem-Kromik M155 (formerly known as Sherwin-Williams M155 or Leighs M155) is a quick drying single-component alkyd anticorrosive protective finish pigmented with zinc phosphate, used for protection of steel where speed of drying is important. Can be applied by aireless spray or roller, using a brush only for small areas or touching up.
Indefinitely overcoatable with a wide range of materials including alkyd, chlorinated rubber and vinyl systems.
Blast clean to Sa21⁄2 BS EN ISO 8501-1:2007. Average surface profile in the range 50 - 75 microns.
Manually prepared surfaces should be prepared to a minimum standard of St3 BS EN ISO 8501-1:2007 at the time of coating.
Ensure surfaces to be coated are clean, dry and free from all surface contamination.
Typical Thickness and Coverage
Dry film thickness
Wet film thickness
*This figure makes no allowance for surface profile, uneven application, overspray or losses in containers and equipment. Film thickness will vary depending on actual use and specification.
Practical Application Rates
Microns per coat
* Maximum sag tolerance typically 231μm wet (125μm dry) by airless spray
- Water / Solvent Based
- For Use On
- Application Method
- Airless Spray, Roller
- Standard / Ready Mixed
- Single, Two or Three Pack
- Pack Size
- 5L, 20L
- 7.2m² per litre
- Touch Dry
- 15 minutes
- UN Number
Be the first to ask a question about this product!