N-Virol Superseal Plus Damp Proofing DPM Paint is a highly advanced styrene butadiene latex based liquid applied membrane which can be used for several applications including damp walls, floors and on basement walls (both internally and externally). It can also be used as a primary waterproofing barrier on new build basements. It offers a simple method for many water proofing and vapour proofing applications.

Quick Links - Click To Jump To Section:

   
• Features & Benefits
• Main Applications
• Application Notes

Features & Benefits

   
• Styrene butadiene latex based liquid applied membrane
• Can be used for several applications including damp walls, floors and on basement walls
• Can also be used as a primary waterproofing barrier on new build basements
• Offers a simple method for many water proofing and vapour proofing applications
• Excellent waterproofing properties
• Brush or roller applied in two coats
• Can be applied to damp substrates
• Quick drying. Typically dry in 1 hour
• Non-toxic, non-hazardous, solvent and plasticiser free
• Low water vapour permeability - Tough, highly flexible - Good crack bridging properties
• Alkali resistant - can be applied to alkaline surfaces - Resistant to silage acids
• Non staining and stain blocking
• Ideal for floors, basements, walls, tiling, water storage and silage storage

Main Applications

N-Virol Superseal Plus can be applied by brush or roller and is effective in the following situations:

Floors:

• Under screeds (or above screeds) to provide a damp proof membrane
• Under laminate flooring & carpets

Basements:

• As part of a waterproofing system beneath ground level

Walls:

• Can be used under render or plaster as a water barrier or vapour barrier

Tiling:

• As a secondary protection under tiles in wet areas e.g. bathrooms, food processing areas, balconies, etc.

Water Storage:

• The membranes perform well even when continuously immersed in water

Silage Storage:

• The membrane protects concrete from silage attack

Application Notes

• The membrane should not be applied in wet conditions or where these conditions are likely to occur before the membrane has dried
• It is sometimes advantageous to pre-wet concrete or masonry backgrounds, so that these are damp but free from any water glistening on the surface
• A minimum dried coating thickness of 0.6mm is necessary to provide a vapour barrier
• This should be applied in a minimum of two coats (i.e. 0.3mm dry film thickness per coat for two applications)
• For the final dried membrane thickness to be 0.60mm a coverage rate of 1.20kg/m² is required (this is the total for all coats). This corresponds to approximately 1 litre/m²
• Available in Black or White
• Please Note:
  • The colour will differ slightly from the colour of the dried membrane
  • The colour shade may vary batch to batch
  • The membrane dries to a tough semi-gloss finish