Bradite Industrial Degreaser
Bradite Industrial Degreaser is an aqueous alkaline low foaming detergent used for degreasing contaminated surfaces prior to painting. Ideally suited for degreasing oily or soiled surfaces and for removing road dirt. Manufactured under the auspices of an ISO 9001:2008 & ISO 14001:2004.
- Biodegradable in general use
- Economical degreasing alternative to solvents
- Mild odour and will not taint food
Bradite Industrial Degreaser is well-suited for degreasing oily or soiled surfaces and for removing road dirt. Active agents degrade according to EU requirements, and in general use, it's biodegradable and can be disposed of into foul drains.
Manufactured under the auspices of an ISO 9001:2008 quality & ISO 14001:2004 environmental management systems.
Features & Benefits
- Economical degreasing alternative to solvents.
- Safe to use.
- Mild odour and will not taint food.
- Biodegradable in general use.
All contaminated surfaces requiring thorough cleaning prior to painting.
Mix thoroughly before use. Application and use should always conform to the codes of practice described in BS 6150 and BS 5493
Brush: thin one part Industrial Degreaser TD39 with 9 parts warm water by volume. Apply diluted solution to substrate and scrub with a stiff bristle brush until heavy contamination is removed. Two or more applications may be necessary depending upon the amount of contamination present. After scrubbing, the surface should be rinsed thoroughly with water and allowed to dry before painting.
Spraying: this product is not recommended for application by spraying.
Clean all equipment immediately after use with water for best results. Always refer to the Health and Safety sheet for the product before use, and observe the warning phrases on the label.
Please contact Rawlins Paints' Technical Support Team on 0113 2455450 for more information.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
Be the first to ask a question about this product!