Sherwin-Williams Macropoxy C400W
We no longer stock this product, but can recommend Sherwin Williams Fast-Clad 7220 as a great alternative.
Sherwin-Williams Macropoxy C400W (formerly known as Epigrip C400W) is a multi-functional epoxy zinc phosphate coating specified for use as a primer on blast cleaned structural steel for internal and external environments. Sherwin-Williams Macropoxy C400W may also be used as a high build intermediate coat as well as the final coat where a low sheen industrial and functional finish is required (not for immersion service).
Specified for use as a primer for structural steel on blast cleaned steel for internal and external environments, it may also be used as a high build intermediate coat as well as the final coat where a low sheen industrial and functional finish is required.
Not for immersion service.
Where good colour and gloss retention is required in an external environment, or a full decorative finish is required in an internal environment, one of our topcoats designed specifically for this role should be chosen. A selection of available topcoats is listed in this data sheet under Recommended Topcoats.
C400W may be applied between 75 and 275 microns DFT in one coat depending on specification requirement.
Indefinitely overcoatable with epoxy systems provided the surfaces to be coated have been suitably cleaned. Where a high degree of gloss and colour retention is required overcoat with Acrolon C137V2, Acrolon C237, Acrolon 1850 and Acrolon 7300 within 7 days at a minimum dft of 50 microns or in the case of Acrolon C750V2 overcoat within 4 days. These overcoating times refer to achievement of optimum adhesion @ 23°C and will vary with temperature.
Application Conditions & Overcoating
This material should preferably be applied at temperatures in excess of 5oC. Relative humidity should not exceed 90% and in these conditions good ventilation is essential.
Substrate temperature shall be at least 3oC above the dew point and always above 0°C.
In order to achieve optimum water and chemical resistance, temperature needs to be maintained above 5oC during curing.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- Water / Solvent Based
- For Use On
- Application Method
- Airless Spray, Spray, Brush, Roller
- Standard / Ready Mixed
- Single, Two or Three Pack
- Pack Size
- 5L, 20L
- 9.2m² per litre
- Touch Dry
- 45 mins
- UN Number (Activator)
- UN Number (Base)
|keith watson on 2020-04-09 08:41:09|| |
Please can you confirm the likely thickness of paint if applied with brush/roller. Thanks
Practical application rates for brush in microns are dry - 65 wet - 94.
Practical application rates for roller in microns are dry - 60 wet - 87.