

Keim Restauro Fuge is a mineral dry bagged premixed restoration mortar with hydraulic binders. Functions as a joint replacement material, especially for natural stone walls.
Keim Restauro Fuge is a mineral dry bagged premixed restoration mortar with hydraulic binders. Functions as a joint replacement material, especially for natural stone walls. It can also be used for facing masonry (brick, sandstone) for joint repairing.
Substrate Preparation
Remove loose material and old coats mechanically or with a water pressure jet. All loose and friable material should be cut back to a sound level.
Preparation
Keim Restauro Fuge is to be mixed only with clean cold water, approximately 5lt per 30kg. For larger quantities use stirring machine or mixer. After a ripening period of 5 minutes the mortar should be of light flow properties. For moulding silicate resin moulds should be used.
Application
Press the prepared joint mortar firmly into the joint with a jointing tool. The new joint material should not be smoothed at the surface. For flush joints, Keim Restauro Fuge should be applied proud of the stone surface and any excess then removed with a palette knife during setting.
Application Conditions
Ambient and substrate temperature above 5°C and below 30°C. Do not apply in direct sunlight or onto sun-heated surfaces, nor if it is raining or if there is an immediate likelihood of rain.
Consumption
Approx. 0.2kg per linear metre for a joint depth and breadth of 1cm x 1cm. Determine actual consumption by tests on trial areas. Consumption rates are offered for guideline purposes only. Actual rates are the responsibility of the applicator. Project specifications should be referred to for specific rates.
Cleaning of Tools
Clean tools with water immediately after use.
Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.
• These colour samples are to be used for guidance only.
• Product contained within is generic to provide a close representation to your chosen colour.
• Should not be used to carry out any painting project, this is for colour selection purposes only and does not remove the need for you to ensure the correct product is chosen and tested for your application once a colour has been decided on.
• It is not a sample of the product you intend to purchase/use and cannot be used to test anything other than colour appearance.
• Notwithstanding any other provision of our conditions of sale, you agree and understand that many factors affect the colour of a painted product, including lighting, sheen level, method of application, batches variances number of coats and substrate surface.
• We cannot therefore promise that the colour of the product you ultimately purchase will exactly match the colour of this colour sample.
• Once you have selected a colour, you must purchase the smallest amount of the product you intend to use in your chosen colour and apply to a small, inconspicuous test area to be sure that it meets your expectations.
• Leave the product for 24 hours and then only buy more paint and/or apply more paint if you are completely happy with the results on the test area.
• We cannot be liable to you for any loss or damage if you have not complied with this process.
• Notwithstanding any other provision of our conditions of sale, you agree and understand that many factors affect the colour of a painted product, including lighting, sheen level, method of application and product surface.
• We cannot therefore promise that the colour of the product you paint with the Kolorbond paint will exactly match the colour of the item you send to us.
• You must therefore purchase the smallest Kolorbond paint pot available first and then apply the paint to a small, and where possible hidden, test area of your product to be sure that it meets your expectations.
• Leave the product for 24 hours and then only buy more paint and/or apply more paint to your product if you are completely happy with the results on the test area.
• We cannot be liable to you for any loss or damage if you have not complied with this process.