Keim Ecotec is a solvent free, silicone micro-emulsion based hydrocarbon concentrate for use as an environmentally friendly water repellent and dust suppressant.
- Environmentally friendly
- Free from solvents, dilute with water
- Excellent water repellency
- Good surface penetration
This product is available as POA. Click here to email us for more information
Keim Ecotec is a solvent free, silicone micro-emulsion based hydrocarbon concentrate for use as an environmentally friendly water repellent and dust suppressant. After mixing with water, Keim Ecotec is used as an environmentally friendly and colourless water repellent, also suitable for use as a dust suppressant.
Top Features & Benefits
- Environmentally friendly.
- Free from solvents, dilute with water.
- Excellent water repellency.
- Good surface penetration.
- Good alkali stability.
- Water vapour permeable.
- Does not change colour.
- Specific Weight: approx. 1.0g/cm3.
- Colour: yellow-transparent.
- Water absorption coefficient: w<0.05/m² -h0.5.
Preparation & Application
All loose, flaking and unstable material must be identified and then thoroughly removed, all surfaces must be thoroughly washed down with clean cold water to remove all surface dirt and dust. When all surfaces are clean, sound, wind dry, dust free and free from all surface contaminants, application of Keim Ecotec may proceed.
The surface should by clean and free from partial damp patches prior to treating with Keim Ecotec.
Keim Ecotec should be mixed to a ratio of 1:9 with water (1 part Keim Ecotec to 9 parts water). This mixture should be used within 24 hours of mixing. Diluted KEIM Ecotec should be applied with low pressure spray and in a flood coat manner, or saturated with a brush from top to bottom.
The consumption is dependant on the capillary absorbency and pore structure of the surface and is between 0.2lt/m² and 0.8lt/m² (premixed). The proportion of Keim Ecotec equates to 0.02lt/m² – 0.08lt/m².
Consumption rates are offered for guideline purposes only and are quoted for smooth surfaces. Actual rates are the responsibility of the applicator. Project specifications should be referred to for specific rates.
Cleaning of Tools
Clean with water immediately after use.
- Application Method
- Spray, Brush
- Single, Two or Three Pack
- Pack Size
- UN Number
Be the first to ask a question about this product!