Sherwin-Williams Firetex M95
We no longer stock this product, but can recommend Nullifire S606 Solvent-Based Intumescent Coating or Sherwin-Williams FIRETEX FX9500 as our nearest alternative. Please contact our Technical Team on 0113 2455450 (option 2) or send a message to [email protected] prior to purchase/use for advice on suitability.
We no longer stock this product, but can recommend Nullifire S606 Solvent-Based Intumescent Coating as our nearest alternative. Please contact our Technical Team on 0113 2455450 (option 2) or send a message to [email protected] prior to purchase/use for advice on suitability.
Sherwin-Williams Firetex M95 is an epoxy intumescent suitable for cellulosic fire protection. Firetex M95 is an exterior durable intumescent, which can be applied directly onto blast cleaned steel.
Suitable for application in-shop and on site, provided the conditions listed in the datasheet are adhered to.
After application, unless a sealer coat is applied prior to exposure, the coating must be protected from the weather until the material reaches a shore D hardness of 50 in order to become exterior durable. Applications below 15°C may result in insufficient curing and reduced weather resistance and performance. See application conditions and over-coating.
Certifire Approved – Certificate CF500
- Macropoxy L574 Blast Primer
- Macropoxy C425V2 Zinc Phosphate Primer
- Macropoxy C400 Range
- Macropoxy M111 Wet Blast Primer
- Firetex C69 Fast-Track Blast Primer
Indefinitely overcoatable with high performance systems provided the surfaces to be coated are free from all contaminants. Where a high degree of gloss and colour retention is required overcoat with Acrolon C137V2 within 7 days at a minimum dft of 50 microns or in the case of Acrolon C750V2 overcoat within 4 days. These overcoating times refer to achievement of optimum adhesion at 23°C and will vary with temperature.
Firetex M95 is indefinitely overcoatable with itself.
IMPORTANT FIRE PRODUCTS NOTICE: The information displayed on this website should be used as a guide ONLY and our Technical Department should be contacted to obtain a tailored specification and any advice necessary before you place an order for fire protection products. Fire protection products are non-returnable except in accordance with Condition 8 of the Terms and Conditions. We will not be held liable for any resulting damage to property, human life or monetary costs incurred due to the incorrect specification you have prepared or use of fire protection products caused by your negligence, including your failure to have contacted us to obtain the relevant advice/specification.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- Touch Dry
- 5 Hours
Be the first to ask a question about this product!