Ennis-Flint Prismo Flexiline Symbols
Ennis-Flint Prismo Flexiline Symbols are the perfect solution to permanently marking car parks, roads, cycleways, airports, docks and playgrounds etc. Quick and easy to apply from standard road markings, to personalised logos and graphics.
Ennis-Flint Prismo Flexiline Symbols are the perfect solution to permanently marking car parks, roads, cycleways, airports, docks and playgrounds etc. Quick and easy to apply from standard road markings, to personalised logos and graphics. Ennis-Flint Prismo Flexiline Symbols provide all your requirements, for hard wearing, quick and easily applied surface marking solutions at any time of the year. With the performance of hot applied thermoplastic, these markings will last for years!
Ennis-Flint Prismo Flexiline Symbols provide exceptionally clean cut, crisp markings that can be trafficked within minutes of application. Prismo Flexiline is available in preformed lines, letters, numbers and symbols. It is one of the fastest ways to permanently reinstate road markings, or produce new markings, providing excellent cost effectiveness. Flexiline requires just one person and a gas torch to apply.
Features & Benefits
- Tough thermoplastic
- Non cracking
- Rapid setting time
- Lay on asphalt or concrete
- Permanent, durable marking
- Wide range of markings available
- Quick and easy to apply
- Clean, crisp road markings in minutes
- Wide range of colours
- Road marking reinstatement
- Car parks
- Corporate logos
- Footpaths / cycleways
Ennis-Flint Prismo Flexiline Symbols are designed to be a quick installation and as easy as possible to accomplish the perfect symbol. Permanent markings can be achieved by one person and a gas torch. Ensure the surface is clean, dry and free from dust, dirt or debris. Warm the road surface over the area to be laid. Layout the Ennis-Flint Prismo Flexiline Symbol in the desired position and remove backing tape. Hold nozzle of the blow torch approximately 6” above the centre of the marking at one end. With a side to side motion, heat the material until it begins to soften and flow into the surface. Retain the distance of the flame from the marking and continue heating. Allow to cool, if fast cooling is required water can be sprayed over to assist.
- If the surface you are applying to is concrete based an additional adhesive will be required in the form of a tack coat - Ennis-Flint Easytack Aerosol
- This thermoplastic road marking is applied by using a professional blow torch lance including regulator - 608 Propane Burner
- For optional retro-reflectivity, Ennis-Flint Reflective Glass Beads are available which are applied to the line during heating.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
Be the first to ask a question about this product!
Colour reproduction of the Products on the Site is limited by the technology used to deliver web pages and by the colour representation of Customer’s own monitor and computer set-up. We have made every effort to display as accurately as possible the colours of our Products but we cannot guarantee that the colour shown on Customer’s monitor’s display will accurately reflect the colour of the Product on delivery. We recommend that Customer first purchases the smallest Product available or access an industry standard colour chart in person (and not digitally) to ensure that the colour is acceptable for its purposes. For more information, please see our Terms & Conditions of Sale.Close