Britannia Marking Paint
A durable and long-lasting marking paint available in an assortment of rich and aesthetically-pleasing colours, for use on cycle lanes or pedestrian walkways. The eco-friendly solution allows for both internal and external use.
- Pedestrian areas and walkways.
- Cycle routes and paths.
- Indoor flooring and walkways.
Painting markings on cycle lanes or pedestrian walkways requires a specifically-formulated paint. Britannia Marking Paint is the ideal choice, and with its array of beautiful and bold colours, you are sure to create floor markings that have impact and get noticed. Consider the following ideal uses for this marking paint:
- Cycle paths - creates clear pedestrian and cycle lane dividers.
- Multi-storey car parks - create straight and easy-to-see parking space lines.
Features & Benefits
- Ideal for tarmac and concrete surfaces.
- Tough and long-lasting.
- Eco-friendly acrylic coating.
- 12-month shelf life.
All surfaces should be dry (not damp). Free from loose or flaking material, dirt grease and vegetative growth. Vacuum or pressure blasting with air or water may remove any debris. Brushing (manual or machine) may be suitable. If in doubt always test a small area prior to use. Not to be applied if there is salt contamination or frost.
Stir can well before use. Surfaces that are cold – below 5°C – are not suitable for coating. Hot surfaces – above 30°C – should be cooled with water spray before application otherwise paint will dry before film formation is completed. Apply an even coat either by brush, roller or by airless spray. Tip size of 28 Thou is recommended for airless spray. A new macadam surface should be left to oxidise for at least four weeks (longer in winter than in summer) before painting. Not suitable for use on open graded macadam or other materials incorporating “cut back” bitumen. New concrete should be allowed to mature for several months before coating. Priming is not normally required, however the first coat on concrete or porous surfaces, should first be thinned up to 10% with water and allow to dry. Apply during April to October (exterior).
Drying is approximately 2-4 hours dependent on ambient temperature. Avoid painting when rain is expected or under poor drying conditions – below 5°C. Curing of the coating can be extended at lower temperatures, dependent on coating thickness, substrate and texture.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- Brush, Roller, Spray
- 6-8 square metres per litre for spray application. Up to 12 square metres per litre for brush or roller application. Dependent on substrate, texture and porosity of the surface. Apply 2 coats.
- Touch Dry
- Approximately 2-4 hours.
Be the first to ask a question about this product!