Condition: New product
Jotun Baltoflake is a glass flake reinforced unsaturated polyester coating. This Jotun product is an ultra high build, extremely abrasion resistant and fast curing barrier coating that can be used as primer, mid coat or finish coat in atmospheric and immersed environments.
Jotun Baltoflake is a glass flake reinforced unsaturated polyester coating. It is an ultra high build, extremely abrasion resistant and fast curing barrier coating that can be used as primer, mid coat or finish coat in atmospheric and immersed environments. Suitable for properly prepared carbon steel, stainless steel, aluminium and approved primers.
Jotun Baltoflake is recommended for areas subject to extreme mechanical wear and harsh exposure conditions. Recommended for offshore environments, including splash zones, jetties, piles, tidal zones, decks, battery rooms, power stations, exterior of buried tanks, concrete bunds, refineries, bridges, mining equipment and general structural steel where future maintenance is chalenging.
Approvals and certificates
- APAS approved to specification 2917, 2917F, 2917P and 2917S
- Norsok M501 / ISO 20340
Additional certificates and approvals may be available on request.
Features & Benefits
- Superior lifetime
- Extreme mechanical strength
- Fast cure
Baltoflake cures so fast that you can walk on it only three hours after application. Perfect for painting in tidal zones where curing time is crucial.
Spray up to 1500 microns in a single coat on a vertical steel surface without sagging.
Baltoflake gives immense strength and protection against water, chemicals, solvents, abrasion or mechanical attack - outperforming traditional protection such as metallizing and epoxy coatings.
Baltoflake is pre-qualified in several NORSOK coating systems (System No. 1 and 7).
IMPORTANT: Jotun additives MUST be bought with this product to ensure drying and correct use. Please refer to the product Technical Data Sheet for information on which additives and how much of each are required. If in doubt, please contact our Technical Department on 0113 2455450.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
|Typical Coverage (per coat)||1.2m² per litre|
|Touch Dry||2 hours|
|The figures stated above are approximate. Please ensure you refer to all datasheets for full application information.|
Be the first to ask a question about this product!
Colour reproduction of the Products on the Site is limited by the technology used to deliver web pages and by the colour representation of Customer’s own monitor and computer set-up. We have made every effort to display as accurately as possible the colours of our Products but we cannot guarantee that the colour shown on Customer’s monitor’s display will accurately reflect the colour of the Product on delivery. We recommend that Customer first purchases the smallest Product available or access an industry standard colour chart in person (and not digitally) to ensure that the colour is acceptable for its purposes. For more information, please see our Terms & Conditions of Sale.Close