

Remmers Restoration Mortar SK is excellently suited for re-profiling weathered sandstone, brick and concrete so that it looks practically like the original.
Remmers Restoration Mortar SK Remmers Restoration Mortar SK is a ready-to-use, factory-mixed, dry mortar made of mineral raw materials (binder and aggregates) and can be feathered out to zero. Its physical characteristics correspond to requirement for the least possible inherent stress and physico-mechanical properties (compressive and tensile bending strength, water transport, etc.) that are coordinated to the natural stone substrate.
Remmers Restoration Mortar SK is excellently suited for re-profiling weathered sandstone, brick and concrete so that it looks practically like the original. Restoration Mortar SK mortar was especially developed for restoring on a small volume scale. The different variations of sandstone or brick colours found in practice can be matched at the plant with practically no deviation from the stone sample. The mortar can also be used for joint work as well as for placing crossings.
Restoration Mortar SK is a component in the Restoration Mortar System and is available in two strengths, thus corresponding to the requirements stated in Prof. Snethlage’s guideline for preserving stone. The grain of the aggregates essentially corresponds to the grading range of fine-grained sandstone. Modifications in the fine and coarse grain range can be made for the specific substrate. If desired, the mortar can also be formulated hydrophobic.
Special colours are available upon request - please contact our Technical Department for more details.
Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.
• These colour samples are to be used for guidance only.
• Product contained within is generic to provide a close representation to your chosen colour.
• Should not be used to carry out any painting project, this is for colour selection purposes only and does not remove the need for you to ensure the correct product is chosen and tested for your application once a colour has been decided on.
• It is not a sample of the product you intend to purchase/use and cannot be used to test anything other than colour appearance.
• Notwithstanding any other provision of our conditions of sale, you agree and understand that many factors affect the colour of a painted product, including lighting, sheen level, method of application, batches variances number of coats and substrate surface.
• We cannot therefore promise that the colour of the product you ultimately purchase will exactly match the colour of this colour sample.
• Once you have selected a colour, you must purchase the smallest amount of the product you intend to use in your chosen colour and apply to a small, inconspicuous test area to be sure that it meets your expectations.
• Leave the product for 24 hours and then only buy more paint and/or apply more paint if you are completely happy with the results on the test area.
• We cannot be liable to you for any loss or damage if you have not complied with this process.
• Notwithstanding any other provision of our conditions of sale, you agree and understand that many factors affect the colour of a painted product, including lighting, sheen level, method of application and product surface.
• We cannot therefore promise that the colour of the product you paint with the Kolorbond paint will exactly match the colour of the item you send to us.
• You must therefore purchase the smallest Kolorbond paint pot available first and then apply the paint to a small, and where possible hidden, test area of your product to be sure that it meets your expectations.
• Leave the product for 24 hours and then only buy more paint and/or apply more paint to your product if you are completely happy with the results on the test area.
• We cannot be liable to you for any loss or damage if you have not complied with this process.