• Sherwin-Williams Cor-Cote FC C800

Sherwin-Williams Cor-Cote FC C800

We no longer stock this product, but can recommend Sherwin-Williams Fast Clad ER or Sherwin-Williams Nova-Plate 325 as a great alternative.

Quantity

Description

Sherwin-Williams Cor-Cote FC C800 is a fast cure, solvent free epoxy amine tank coating designed for immersion service in fuel and petroleum storage tanks where a rapid return to service is required.

Resistance to:

  • Petrol – Excellent
  • Diesel – Excellent
  • Kerosene – Excellent
  • Ethanol – Very Good
  • Boiling Water – Excellent

Endorsements

  • Meets the performance requirements of MIL PRF 4556

Recommended Uses

  • As a tank lining offering a rapid return to service in a number of petrochemical fuels and cargos
  • As a high build finish for use on the internal surfaces of water tanks and pipes

Application Equipment

The following is a guide. Changes in pressures and tip sizes may be needed for proper spray characteristics. Always purge spray equipment before use with listed cleanser solvent. It is not recommended to thin this material.

Cor-Cote FC C800 is applied using dual component hot airless spray application equipment. The following is a typical set up for application of Cor-Cote FC C800:

Airless Spray

Operating Temperature: 30-35oC/85-95oF at tip
Nozzle Size: 0.48mm-0.53mm (19-21 thou)
Operating Pressure: 176kg/cm² (2500 psi) at the tip 

The airless spray details given above are intended as a guide only. Details such as fluid hose length and diameter, paint temperature and job shape and size all have an effect on the spray tip and operating pressure chosen. However, the operating pressure should be the lowest possible consistent with satisfactory atomisation. As conditions will vary from job to job, it is the applicators' responsibility to ensure that the equipment in use has been set up to give the best results.

Brush

The material is suitable for brush application to small areas and for touch up purposes. Application of more than one coat may be necessary to give equivalent dry film thicknesses to a single spray applied coat. 

It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.

Product Details

Data sheet

Manufacturer
Sherwin-Williams
For Use On
Metal
Application Method
Brush, Spray
Sheen
Gloss
Colour
Standard / Ready Mixed
VOC Levels
Ultra-Low (5-49 g/l)
Single, Two or Three Pack
Two-Pack
Pack Size
30L, 60L
Application
Brush, Spray
Touch Dry
2.5 Hours
UN Number (Activator)
UN3066
UN Number (Base)
UN3082
Attachments
Download


Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.


Be the first to ask a question about this product!


Question about the product

* Required fields
(read)
Send