Blackfriar Professional Water Based Floor Sealer is a clear, water-based, low-odour sealer. Ideal for binding, stabilising and sealing friable (loose) and porous surfaces prior to finishing with water-based coatings. Easy and safe to use.
Product Features
Specifically designed to seal bare and porous concrete substrates.
Low-odour - ideal for confined or sensitive areas.
Use prior to coating with Blackfriar Professional Acrylic Floor Paints.
Also suitable to apply under water-based masonry paints.
Blackfriar Professional Water Based Floor Sealer is a clear, water-based, low-odour sealer. Ideal for binding, stabilising and sealing friable (loose) and porous surfaces prior to finishing with water-based coatings.
Preparation
Ensure the surface to be painted is sound, clean, dry and free from grease or any substance liable to give adhesion problems. Scrape off any old or flaking paint until you have a firm surface. Special attention should be given to areas under cars to ensure all oil, grease, dirt and road salt is removed. New concrete must be left for at least 6 months before applying Blackfriar Professional Water Based Floor Sealer.
Application
Stir thoroughly before use. Apply with a brush or roller working the paint in any surface imperfections. Blackfriar Professional Water Based Floor Sealer is not suitable for use over non porous substrates like PVC, thermoplastic tiles, quarry tiles, asphalt floors or granolithic concrete.
Do not apply it on concrete surfaces treated with alkali containing liquids, areas subjected to rising damp or areas treated with PVA bonding solutions. Do not apply in cold (below 10°C), damp or humid conditions. If concrete floors are very smooth then pre-treat with Blackfriar Professional Acid Etch followed after thorough rinsing by Blackfriar Professional Water Based Floor Sealer.
Drying Time
2-4hrs @20°C. Allow to dry for a minimum of 4hrs @20°C between coats. Full cure is achieved in 3-5 days @20°C.
Clean Up
Remove as much product from application equipment as possible before washing with water. Do not empty into drains or watercourses. Some local authorities have special facilities for the disposal of waste coatings.
Product Features
Specifically designed to seal bare and porous concrete substrates.
Low-odour - ideal for confined or sensitive areas.
Use prior to coating with Blackfriar Professional Acrylic Floor Paints.
Also suitable to apply under water-based masonry paints.
Brush or roller application.
Indoor and outdoor use.
Please contact Rawlins Paints' Technical Support Team on 0113 2455450for more information.
Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.
Hello, I wanted to know if the Sealer, Blackfriar Professional Water Based Floor Sealer (Reference BF2070008) could be used under a water-based 2-part Epoxy paint coating on a concrete garage floor. Thanks, Mark Grimshaw
Answer:
This product is recommended for use prior to Blackfriar Professional Acrylic Floor Paints.
You would need to contact the screed manufacturer to ensure their material can be over painted with a single pack, water based floor sealer.
Ash on 2018-01-29 20:00:18
Question:
Can this be used on screed?
Answer:
We suggest you check with the screed manufacturer to ensure the screed will take a paint system and in this instance a water based coating. Provided the screed is suitable for painting and the Blackfriar Professional Water Based Floor Sealer is suitable for your environment, traffic level, etc. then it can be used.
Blackfriar Professional Acid Etch is a surface preparation solution for use on concrete and screed floors that removes excess lime dust (laitence) which can interfere with the adhesion of floor coatings.
Product Features
Hydrochloric acid solution.
Etches power floated, very smooth, hard or chemically treated concrete floors to ‘key’ the...
Floor Application Kit from Rawlins Paints provides all the application equipment needed to apply conventional floor paints and coatings to a professional standard. The application of floor coatings is often crucial to their performance, so it is important to use the right tools to ensure a lasting finish.
Each kit contains:
12" Roller,...
• These colour samples are to be used for guidance only.
• Product contained within is generic to provide a close representation to your chosen colour.
• Should not be used to carry out any painting project, this is for colour selection purposes only and does not remove the need for you to ensure the correct product is chosen and tested for your application once a colour has been decided on.
• It is not a sample of the product you intend to purchase/use and cannot be used to test anything other than colour appearance.
• Notwithstanding any other provision of our conditions of sale, you agree and understand that many factors affect the colour of a painted product, including lighting, sheen level, method of application, batches variances number of coats and substrate surface.
• We cannot therefore promise that the colour of the product you ultimately purchase will exactly match the colour of this colour sample.
• Once you have selected a colour, you must purchase the smallest amount of the product you intend to use in your chosen colour and apply to a small, inconspicuous test area to be sure that it meets your expectations.
• Leave the product for 24 hours and then only buy more paint and/or apply more paint if you are completely happy with the results on the test area.
• We cannot be liable to you for any loss or damage if you have not complied with this process.
Colourmatch Service Disclaimer
• Notwithstanding any other provision of our conditions of sale, you agree and understand that many factors affect the colour of a painted product, including lighting, sheen level, method of application and product surface.
• We cannot therefore promise that the colour of the product you paint with the Kolorbond paint will exactly match the colour of the item you send to us.
• You must therefore purchase the smallest Kolorbond paint pot available first and then apply the paint to a small, and where possible hidden, test area of your product to be sure that it meets your expectations.
• Leave the product for 24 hours and then only buy more paint and/or apply more paint to your product if you are completely happy with the results on the test area.
• We cannot be liable to you for any loss or damage if you have not complied with this process.
*All estimates are based on theoretical consumption rates for a single coat and do not take into account any substrate deviations or wastage
*All estimates are based on theoretical consumption rates for a single coat and do not take into account any substrate deviations or wastage
* All estimates are based on theoretical consumption rates for a single coat and do not take into account any substrate deviations or wastage
Mark Grimshaw on 2020-07-01 19:28:15
