International Intertuf 16
  • International Intertuf 16

International Intertuf 16

JBA016

International Intertuf 16 is a one component, high build cold applied bituminous coating for use as an economical coating ideally suited for the protection of interior steel surfaces in enclosed areas such as tanks for storage of sea water, immersed piping and structural steelwork.

  • As an economical coating ideally suited for the protection of interior steel surfaces in enclosed areas such as tanks for storage of sea water, immersed piping and structural steelwork.
  • International Intertuf 16 is suitable for use at low temperatures and over power tool cleaned steel where performance expectations are consistent with such preparation methods.

Colour
Size
£30.03
VAT excluded

£36.04 Tax incl.
Quantity

Description

International Intertuf 16 is a one component, high build cold applied bituminous coating. Normally a minimum of two coats to give 250 microns (10 mils) is required to give good anticorrosive performance on water immersion.

Intended Uses

  • As an economical coating ideally suited for the protection of interior steel surfaces in enclosed areas such as tanks for storage of sea water, immersed piping and structural steelwork.
  • International Intertuf 16 is suitable for use at low temperatures and over power tool cleaned steel where performance expectations are consistent with such preparation methods.

International Intertuf 16 has the following specification approvals:

  • UK Department of Transport Item No. 141

It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.

Product Details
JBA016

Data sheet

Manufacturer
International
For Use On
Steel
Application Method
Brush, Roller, Spray
Colour
Standard / Ready Mixed
Single, Two or Three Pack
Single
Product Certifications
UK Department of Transport Item No. 141
Pack Size
5L, 20L
Application
Brush, Roller, Spray
Coverage
4.2m² per litre
Touch Dry
8 Hours
UN Number
UN1263
Attachments
Download


Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.


questions Mike Napthine on 2018-07-12 11:17:51
Question: 

Hi, I have a new build narrowboat with intertuf 16 on the hull. Boat manufacturer has advised reblacking after the first year so due now really. Can you advise on what product is best. I was just going to pressure wash the hull and use the existing coats as a key where possible. TIA

Answer: 

We would recommend abrading areas where the coating is loose or missing International Intertuf 16, jet wash and apply another coat of the same over the top.

If you want longer without lifting out every year, you could get it blasted and apply International Interzone 954 by spray (to 500 microns DFT) and get 5-10 years without lifting.

questions Malc Gwilliam  on 2018-02-28 15:41:03
Question: 

Please advise can Intertuf 16 be purchased in 2.5ltr or 1ltr tins Thanks Malc

Answer: 

No, only 5L or 20L.


Question about the product

* Required fields
(read)
Send