Rust-Oleum Non-Skid Additive NS 200
Rust-Oleum Non-Skid Additive NS 200 is a specially selected non-skid additive that can be mixed with the required Rust-Oleum coating system or sprinkled into the freshly applied coating to produce a non-skid surface.
Rust-Oleum Non-Skid Additive NS 200 is based on thermally split flint stones and is intended to be added to floor coatings to produce a non-skid surface. Rust-Oleum Non-Skid Additive NS 200 can be used in combination with the following Rust-Oleum Floor coatings:
- Rust-Oleum 5500 Solvent Free Epoxy
- Rust-Oleum 9100 Epoxy
- Rust-Oleum 9600 Rust-O-Thane Polyurethane
- Rust-Oleum Mathys Pegakote
- Rust-Oleum 9700 Coldmax Rapid
- Rust-Oleum 5800 Epoxy Rapid WB
Rust-Oleum Non-Skid Additives can be mixed with the required Rust-Oleum coating system or can be sprinkled into the freshly applied coating manually or with special low pressure spraying equipment. Rust-Oleum Non-Skid Additives are intended for Non-Skid industrial flooring and should be topcoated with the required Rust-Oleum System if sprinkled.
Directions for Use
Sprinkling: Sprinkle the granulates onto the freshly applied, wet Rust-Oleum coating, manually with a "sprinkler-box" for small areas, or with special low-pressure spraying equipment with a nozzle opening of at least 18mm; air pressure between 1 - 3 bars.
Mixing: Mix the granulates into the wet coating material and apply the coating with a roller or a brush (not by spraying), stir regularly to avoid settling of the granulates.
Note: For coating systems with a dry film thickness less than 300μm it is recommended to use NS 200.
- Sparingly: 20 m²/kg (= 200 g/l if mixed in)
- Dense: 10 m²/kg (= 400 g/l if mixed in)
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
Be the first to ask a question about this product!
Colour reproduction of the Products on the Site is limited by the technology used to deliver web pages and by the colour representation of Customer’s own monitor and computer set-up. We have made every effort to display as accurately as possible the colours of our Products but we cannot guarantee that the colour shown on Customer’s monitor’s display will accurately reflect the colour of the Product on delivery. We recommend that Customer first purchases the smallest Product available or access an industry standard colour chart in person (and not digitally) to ensure that the colour is acceptable for its purposes. For more information, please see our Terms & Conditions of Sale.Close