Blackfriar Quick Drying Radiator Paint is specially formulated for interior use on radiators, pipework and storage heaters. Blackfriar Quick Drying Radiator Paint can withstand temperatures of up to 150°C/300°F. Hard wearing brilliant white finish does not yellow with age.
Preparation
Ensure surface to be coated is clean, dry, sound and free from wax, grease or any other contamination. Previously painted surfaces in sound condition should be finely abraded and degreased prior to direct application of Blackfriar Quick Drying Radiator Paint. Remove any rust and abrade back to a clean bright surface before priming with Blackfriar Multi-Surface Primer.
Coat new or bare areas with Blackfriar Multi-Surface Primer.
Application
Stir thoroughly prior to use with a broad stirrer. The product may be applied by brush, roller or spray. If brushing, use a good quality soft brush, apply with light strokes finishing off in one direction. Leave to dry for one hour then turn the radiator on for one hour. Allow to cool then apply another coat if required following the same procedure.
If spraying, the product may be thinned up to 10% with water if needed.
Thinning
Maximum 10% water.
Limitations
Do not use under cold (less than 10°C), damp or humid conditions. Do not apply to warm or hot surfaces. Protect from water or steam for 2-3 days after application. Avoid using harsh cleaning agents on the finish.
Drying Time
Touch dry in 1 hour. Heat radiator between coats.
Clean Up
Remove as much product as possible from application equipment before washing with water. Do not empty into drains or water courses. Some local authorities have special facilities for the disposal of waste coatings.
Storage
Store in a dry, safe place. Do not store in environments where extreme temperatures may occur. Keep within 5-30°C. Do not store in direct sunlight.
Features
- Heat-resistant to 150ºC/300ºF
- Tough and durable
- Non-yellowing
- Interior use
Note: Apply to a cold radiator, leave to dry for 1 hour then heat radiator to full heat for 1 hour and allow to cool prior to applying the second coat
Please contact Rawlins Paints' Technical Support Team on 0113 2455450 for more information.